SKY-HERO Little Spyder Instruction Manual

Motor Wedges
Instruction Manual
Motor Wedges
2
CONGRATULATIONS!
hope that it will provide you lots of fun during your many ights. This manual will help you to com­plete the installation and to nd the references of the parts needed.
WARNING :
Read all of the instruction manual to familiarize yourself with the characteristics of the product before operating. Improper use of the product can cause its deterioration and risk of damage or injury.
requires basic mechanical skills. Any irresponsible use of this product not complying with not secu-
rity principles can cause injuries, cause property damage and - damage the product. This product is not intended to be used by children without supervision direct of an adult. This manual contains
instructions for safety, operation and maintenance. It is essential to read and follow all of the ins­tructions and warnings of manual before assembly, setting and use, in order to properly handle the appliance to avoid damage or serious injury.
14 years and older. This is not a toy.
Precautions and guidelines related to security
• Always keep an adequate safe distance in all directions around the device in order to avoid the risk of collision or injury. This unit is controlled by radio signal and may be subject to interference from
many sources outside your control. Interference can cause momentary loss of control.
• Always use the device in open spaces, away from the vehicles, trafc and individuals.
• Always carefully follow the instructions and warnings on the unit and to all used optional additional
equipment (Chargers, packs of rechargeable batteries, etc.).
• Keep chemicals, small parts and electrical components out of reach of children.
• Do not expose to water all equipment designed and protected for this purpose. Moisture damage
the electronic components.
• Never put any part of the appliance in your mouth. You will be exposed to serious injury or even
death.
• Never use the appliance when the batteries of the transmitter are almost empty.
• Always keep the multicopter in view and under control.
• Always lower the throttle stick when the blades touch an object or the ground.
• Always use fully charged batteries.
• Never turn off the transmitter when the unit is powered.
• Always remove the batteries before dismantling the instrument.
• Always clean the moving parts.
• Always dry the parts of the appliance.
• Always cool the parts before touching.
• Always remove batteries after use.
• Never use the appliance when the cables are damaged
• Never touch moving parts.
3
TABLE OF CONTENTS
Introduction.
Tools needed.
Hardware components.
1. Motor assembly.
2. Identify the supports (front and rear).
3. Assemble the motor wedges.
4. Select your angle.
5. Mount the supports on your motor frames.
6. Apply Loctite from the top.
Listing and parts references.
Limited Warranty
Contact
page 2
page 4
page 5
page 6
page 8
page 9
page 10
page 11
page 12
page 13
page 14
page 15
4
TOOLS NEEDED
2 mm hex wrench
2.5 mm hex wrench
3 mm hex wrench
7 mm wrench
Blue thread (Loctite)
5
Button Head screw M3 X 6mm
Button Head screw M3 X 10mm
Flat Head screw M4 X 14mm
Hex Nut Nylstop M4
Washer M3
Socket Head Screw M3 X 10mm
HARDWARE COMPONENTS
Loading...
+ 11 hidden pages