• Installation
Follow the four steps below for connection to your single or two-line
telephones.
Plug "T Adapter"
1
into phone jack.
Connect Phone and
2
T-700 to "T Adapter"
Audio Source
Phone Jack
Plug T-700 into
3
120V Wall Outlet.
AC Outlet
Lights on phone don't work when on hold
•
Change the "LIGHT SWITCH" to a different position. Try all three
positions if necessary. (see below)
No Audio
•
Open lid. Pick up phone and press the * key. The red LED for the
line you are on, in the T-700, (see below) should light for about 4 seconds.
Audio should be heard through the ear piece of the telephone. If no audio is
heard check the following:
Make sure the audio source is playing.
!
Make sure the volume on the audio source is turned up.
!
Make sure that the audio cable is connected from the headphone
!
output of the audio source, to the audio jack on the T-700. Make
sure the type of jacks on the cable are the correct type. (male
phono or RCA for the T-700).
Music does not shut off when phone picked up
•
Connect audio cable from
4
T-700 to Audio Source.
• Operation
To place a call on hold
•
NOT
Do
phone. The caller will hear the audio source that you have connected to the
adapter. Note: if you do not hang up your phone within 4 seconds, the
adapter will automatically reset.
To release the hold condition
•
Pick up any phone that is connected to that line and the adapter will
automatically release the call.
press the hold button!!...simply press * and hang up the
• Troubleshooting Guide
Open the lid by removing the 4 Phillips head screws; you will see the
circuit board to the right.
Open lid. Change the "LIGHT SWITCH" to a different position. Try all
three positions if necessary.
Music cuts off after placing call on hold
•
Hang the phone up after pressing the * key, do not press the hold
button on your telephone.
1 2 3
Tech Support - 916-786-6186
If you have any problems getting the T-700 to work properly feel free to
give us a call. Technical Support is available between the hours of 7:30 AM
and 4:30 PM Pacific Time, Monday through Friday.
ONE YEAR LIMITED WARRANTY
This SKUTCH PRODUCT is warranted against defects for a period of
one (1) year from the date of the original invoice. Within this period, we will
repair it without charge for parts and labor. To obtain warranty service the
product must be returned, at the customer's expense, to SKUTCH Electronics
along with a copy of the original invoice. After the unit has been repaired,
SKUTCH will ship the PRODUCT back via UPS GROUND service at our
expense. If any other form of return shipment is requested, the customer will
pay for 100% of the shipping cost.
This Warranty does not apply if in the sole opinion of SKUTCH
Electronics, the PRODUCT has been damaged by lightning or any other Acts
of God, or by accident, misuse, neglect, or improper packing, shipping,
modification or servicing by other than an authorized SKUTCH Service
Center.
EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT,
THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES
OR MERCHANTABILITIES OR FITNESS FOR A PARTICULAR
PURPOSE AND IN NO EVENT SHALL SKUTCH ELECTRONICS BE
LIABLE FOR LOSS OF PROFITS OR BENEFITS, INDIRECT, SPECIAL,
CONSEQUENTIAL OR OTHER SIMILAR DAMAGES ARISING OUT
OF ANY BREACH OF THIS WARRANTY OR OTHERWISE.
Command Codes
####1
####2
= Star to activate (*)
= Pound to activate
"Telecommunication Products to solve Telecommunication Problems"
T-700
"Touch Tone" 2 Line Promotion On Hold
Sa Pw rdtereo
Adapter
S/N A104001 and Above
####3
####4
####6
####7
= Short Touch Tone
= Long Tone Detect (*)
= Hold Key Mode
= Reset to Defaults (*)
Version 5.1
Loading...