SKUTCH CK1R User Manual

"Telecommunication Products to solve Telecommunication Problems"

CK1R

Modular Phone Cords (2)

Promotion-On-Hold

Module

For the RCA 25450RE3 telephone system

CK-1R Black Box

Sensor Board Cable

Audio Cables (Use Only One)

Sensor Board

9/13/06

Introduction

Thank you for purchasing the Skutch CK1R Promotion-On-Hold Module for the RCA
25450RE3 four line cordless phone system. The CK1R adds Promotion-On-Hold
capability to the phone system. The CK1R is a true plug and play device. The unit does
not require any "Learning" to operate. When a call is placed ON HOLD from any
cordless phone or the base station, the ON HOLD caller will hear the Promotion-On-Hold
audio. When the line is re-answered, the audio automatically stops. It's that simple!

Power Cube

Installation

1- On the base telephone, make sure that the surface area around the “LINE

BUTTONS” is clean and free from any dust or oil film. The surface MUST be
clean in order for the “SENSOR BOARD” to stick properly.

2- Locate the “SENSOR BOARD”. Peel all three paper protectors off back side, and

carefully align as shown in Fig. 1 . Notice that the “Right” edge of the “SENSOR
BOARD” is aligned to edge “A” of the phone on Fig. 2, and that the lights and
buttons on the “SENSOR BOARD” are centered directly over the LINE
BUTTONS on the base phone.

3- Once you are SURE it is aligned, press down to attach to phone.

Page 1 of 5

Edge “A”

Centered

Figure 1

Edge “A”

On phone

Figure 2

Over Line
Buttons

CAUTION: The SENSOR BOARD must be mounted and aligned correctly on the base
telephone, or the unit will not operate properly. If you need to remove the SENSOR
BOARD, slowly lift up on one edge of the SENSOR BOARD. Pulling the SENSOR
BOARD off too fast, will damage the foam pads. Excessive removal of the SENSOR
BOARD will weaken the adhesive on the SENSOR BOARD and will prevent it from
staying attached. If the SENSOR BOARD fails to stay attached to the phone, use a small
amount of Contact Cement, carefully applied with a Q-TIP, to re-attach the Sensor
Board. You MUST let the Contact Cement air cure for at least 20 seconds before
attaching to the phone. Please call for technical support for proper assistance in
cementing the SENSOR BOARD to the phone. DO NOT use any other type of glue,
cement, or tape on the SENSOR BOARD.

4- The CK-1R black box can not be located under the base phone like other CK1

units.

5- Connect the SENSOR BOARD CABLE between the CK1R Box and the

SENSOR BOARD as shown in Fig. 3.

To Black Box

3&4 to Phone

L4/Data

L4/L3

To Black Box

1&2 to Phone

L2/L1

L2

Jacks on Rear of Phone

6- Disconnect the modular cable that is connected to the RCA Phone, at the “L2/L1”

jack and hold it in your hand. Now connect the cord in your hand, to the [1&2 To
Line] jack on the CK-1R Black Box.

Page 2 of 5