SKUTCH CK-1P5 User Manual

"Telecommunication Products to solve Telecommunication Problems"

CK-1P5 Installed on Phone

CK-1P5

Promotion-On-

Hold Module

For the Panasonic KX-TS4100,
KX-TG4200, and KX-TGS4300
Phones

1/8/2014--V4

Introduction

Thank you for purchasing the
Skutch CK-1P5 Promotion­On-Hold Module for the

Panasonic KX-TGS4100, KX­TG4200, and KX-TS4300 four
line phone family. The CK­1P5 works ONLY with these
three phone models. The CK­1P5 is a true plug and play
device. The unit does not
require any "Learning" to
operate. When a call is placed
ON HOLD from any one of the
phones, the ON HOLD caller
will hear the Promotion-On­Hold audio. When the line is
re-answered, the audio
automatically stops. The CK­1P5 requires an external Audio player to supply the audio.

Audio Cable

Sensor Board

(RCA to RCA)

3.5mm to RCA Adapter

CK-1 Box

Flat Cable

Power Cube

Installation

The CK-1P5 can be installed on any one telephone, and it will work from all phones that
are within the family (The 3 Models ONLY).

1- Make sure that the surface on the telephone is clean and free of dust and/or oil.

Page 1 of 4

2- Peel the paper protector off back side of the "SENSOR BOARD" . Carefully align as
shown in the picture below. The Sensor Board will almost snap into place, as it is
designed to fit the contour of the phone. The Sensor Board will completely cover the
Line 1 through 4 buttons on the phone. The LEDS on the Sensor Board do NOT align to
the LEDS on the phone.

Sensor Board Alignment

Sensor Board Covers Line
1-4 Buttons on Phone. It fits

the contour of the phone for
easy alignment.

CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not operate
properly. If you need to remove the SENSOR BOARD once it is attached, slowly lift up
on one edge of the SENSOR BOARD.

3- Position the CK-1 box under the base telephone with the jacks facing towards the back
of the phone. (See Fig. 3).
4- Connect the short modular cord from [1&2 to Phone] on CK-1 to [LINE 1/2] on
Phone.
5- Connect the short modular cord from [3&4 to Phone] on CK-1 to [LINE 3/4] on
Phone.
6- Connect the RCA end of the Audio cord, to the AUDIO IN jack on the back of the
CK-1 box. Connect the other end to your audio source. If your audio source has a 3.5mm
audio connector, use the supplied audio adapter on the end of the cable.
7- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 to Line] on CK-1.
8- Connect a MOD cord from Telephone Wall Jack 3&4 to [3&4 to Line] on CK-1.
9- Connect the POWER CUBE from the CK-1 box to 115VAC power.

Page 2 of 4