SKUTCH CK-1A7 User Manual

"Telecommunication Products to solve Telecommunication Problems"

SENSOR Board

CK-1A7

Power Cube

Promotion-On-Hold

Module

For the AT&T TL86109

2 line telephone

05/16/12

Audio Cord

with Adapter

CK-1A7
Box

Flat Cable

Introduction

Thank you for purchasing the
Skutch CK-1A7 Promotion-On-Hold
Module for the AT&T TL86109 two
line expanded phone system. This
unit will ONLY provide Promotion­On-Hold to calls placed on HOLD on
the two analog telephone lines from
this phone. It will not provide
Promotion-On-Hold on any Cell
Phone that has been PAIRED to this
phone. The CK-1A7 ONLY works
with this phone model. The CK-1A7
is a true plug and play device. This
unit requires an external sound source
such as a CD or Digital Player to
provide the Promotion-On-Hold
audio. When a call is placed ON
HOLD, from the base or any of it’s
cordless phones, the ON HOLD caller
will hear the Promotion-On-Hold audio. When the line is re-answered, the audio
automatically stops. It's that simple!

CK-1A7 Installed on TL86109

Installation

The SENSOR Board MUST be attached to the phone or this unit will not function. The
Sensor board has been custom molded to fit the TL86109 telephone so alignment is very

Page 1 of 4

easy. The SENSOR board completely covers the Line 1 and Line 2 push buttons on the
phone.
1- Make sure that the surface on the telephone is clean and free of dust and/or oil.
2- Peel the paper protectors off back side of the "SENSOR BOARD" . Carefully slide
SENSOR board snug against corner of phone as shown in Fig. 2. The Sensor Board
MUST completely cover the line selector buttons on the phone. Once you are SURE it is
aligned correctly, press down firmly to adhere to phone.

CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not
operate. If you need to remove the SENSOR BOARD once it is attached, slowly lift up
on one edge of the SENSOR BOARD.

FIG #2

SENSOR Board
fits contour of phone

Before

After

Page 2 of 4