Skreddy Top Fuel User Manual
Power
High-gain tone that retains articulation at all
settings
Sustain: This controls the intensity of the distortion. The
sweetest, fuzz-like tones are at the highest settings of the
sustain control
Volume: This sets the output volume. You can adjust your
Skreddy Pedal to roughly the same volume as your bypass
signal (aka “unity gain”) or you can boost your signal for a
fatter tone.
Tone: This is not your standard tone control. The Top Fuel
emphasizes the midrange, where your guitar’s primary focus
and articulation are found. This tone control allows you to
fine-tune the sound from darker and richer (left) to brighter and
more cutting (right).
9v battery is not included. To install or change a battery,
remove the bottom cover using a Phillips screw driver. To
prevent a battery (if you use one) from draining while the pedal
is not in use, remember to un-plug the input cable from the
pedal’s input jack. The battery is also disconnected from the
circuit when an adapter is plugged into the DC jack.
We include a protective cover on the battery clip to prevent it
from shorting against anything inside the box if you do not use
a battery.
You may also supply external power through an AC adapter.
All Skreddy Pedals accept the industry-standard 9v DC plug
(5.5mm barrel x 2.1mm center coax), with the center being
negative and the barrel being positive. Please use a quality,
regulated, filtered power supply.
Service
Email Skreddy Pedals at marc@skreddypedals.com if your
pedal needs repair.
Loading...