SKP Pro Audio COMBO I,COMBO II User Manual

COMBO I

COMBO II

Power Amplifier

4 channal

User Manual

CAPABILITIES, SPECIFICATIONS AND FEATURES

CONTROL PANEL

1. – Line input.
Unbalance line in.
1/4”jack input connector style.

2. – Mic input.
Balance input.
XLR input connector style.

3. –Volume control
Channel Level Control Output
Adjust level on all four channel.

4. – Treble control.
Control high on each channel.
Cut or boost range of +/- 15dB.

5. – Bass control
Control bass on each channel.
Cut or boost range of +/- 15dB.

6. – Digital delay gain control.
Adjust effect level on each channel.

7. – Master level contro
Adjust voiume of the master output.

8. – CD/TAPE level control
Adjust volume for stereo input.
Control level for an audio source(CD,Tape deck etc.)

9. – Digital delay master volume.
Adjust level for the digital effect on the master signal.

10. – Digital delay depth control.
Adjust amount of depth in the digital delay signal.
Adjust echo to reverb effect.

11. – Digital delay time control
Control length and number repeat.

REAR Panel

1. – Send output connector
Loop connection.
Unbalance line mono output.
1/4” jack output connector style.
When used, takes the signal the master output, interrupting the signal that goes to
the internal amplfier. (This signal goes to the signal processor such
as,delays,reverbs,compressor)

2. – Return input.
Loop connection
Unbalance line mono input.
1/4” jack output connector style.
When used, brings the signal back to the amplifier input
(This signal comes back from the signal processor such as delays,reverbs,
compressor,etc)

3. – Speakers output.
1/4” connector output.

Two mono output.
Handle two speaker boxes 8 Ohm.

4. – Stereo input(CD,tapes etc.)
Two RCA connector style.
High impedance stereo input.

5. – AC power conector.
Standard IEC connector.
110V – 220V,(Switchable)

6.- Fuse holder
2 amp (110 V).
1 amp (220 V). `

7. Voltage selector
Selectin between 110V / 220 V 1ts.

CAPABILITY
100 W @ 4 Ohm, two speaker output (8 ohm).
4 channcl balance or unbalance input.
XLR or 1/4” connector type on each channel.
15V phantom power.
Volume control,tow band equalizer per channel.
Built in Digital Delay Effect on each channel.
Independent Stereo input,RCA connector style for (CD,Tape deck,etc.)
Send and return effects loop.
Master volume control.
CD/Tape volume control.
Delay,Depth and Volume control for Digital Delay effect.

SPECIFICATIONS
Output Power 100 W at 4 ohm

Frequency Response: 30Hz. - 16Khz +/-3dB
Total Harmonic Distortion(THD)+Noise: < 0.85.
Inputs(max,sensitivity / Impedance): 4 X MIC: 6 mV / 1 Kohms..

4 X Line: 60 mV / 15 Kohms.
1 X Return: 800 mV / 15 Kohms.

2 X CD/ TAPE: 300 mV / 25 Kohms.
Output(max,out / Impedance): 1 X Send: 850 mV / 100 K 1 V (60 Hz).
Power Supply: 110 / 220 V(Switchable)
Fuse: 2 amp. (115 V) / 1 amp. (230 V)
Dimensiones: 48 X 26,5 X 28 cm
Weight: 8 Kg

COMBO I

COMBO II

Mezclador Amplificado

4 canales

Manual de Uso