Skope CONSORT PLC075TI, CONSORT PLC125TI, CONSORT PLC150TI, CONSORT PLC200TI Operating Instructions Manual

PLC075TI, PLC125TI,
PLC150TI, PLC200TI

SKOPE CONSORT
Convection Panel Heaters

Installation and Operating Instructions

MAN0981 Rev. 2.0 March 2010

2

PLC075TI, PLC125TI, PLC150TI, PLC200TI

SKOPE CONSORT Convection Panel Heaters

Safety Information

When using any electrical appliance, safety precautions should always
be observed. Read these instructions carefully, and retain for future
reference. For service, contact your nearest authorised service agent.

•When used by, or near, young children or infirm persons, close
supervision is necessary. Young children should be supervised to
ensure that they do not play with the appliance, nor touch
anywhere near the outlet grille.

•Do NOT touch the outlet grille, as it is VERY hot.

•Do NOT use this appliance other than for its intended use.

•Do NOT cover the grilles or place any object or material up against
the unit, as this may block entry or exhaust of airflow.

•Do NOT probe any opening to remove fluff. To ensure trouble-free
performance it is recommended that on a regular basis the unit be
isolated from the power supply and a vacuum cleaner used to
remove dust and fluff from the inlet and outlet grilles.

•Do NOT allow the supply cord to come into contact with heated
surfaces during operation.

•Use this appliance with the voltage specified on the rating label.

•Be very careful not to touch hot surfaces or moving parts.

•If the supply cord becomes damaged, it must be replaced by a
SKOPE authorised service agent, or similarly qualified person, in
order to avoid a hazard.

•Regulations require that electrical work be carried out by
authorised persons. For your own safety and that of others, ensure
this is done.

3

PLC075TI, PLC125TI, PLC150TI, PLC200TI

SKOPE CONSORT Convection Panel Heaters

Installation Regulations

This appliance MUST be installed in accordance with relevant wiring
rules and regulations which cover installation of appliances and
accessories in damp situations such as bathrooms, showers, laundries
and other areas with fixed water containers (in Australia and New
Zealand - AS/NZS 3000:2000 Wiring Rules).

IMPORTANT: The heater must not be located immediately below a
socket outlet. A suitable disconnection device (acting in all active
supplies) is required to be incorporated in the fixed supply wiring.

The heater must be mounted a minimum distance of:

•150mm from floor level

•400mmm below a fixture or ceiling

•300mm from adjacent walls

Installation Dimensions

Model A B C

PLC075TI 442mm 196mm 123mm
PLC125TI 614mm 364mm 125mm
PLC150TI 680mm 488mm 96mm
PLC200TI 852mm 616mm 118mm

Figure 1: Installation dimensions