Depending on equipment fitted:
▶
- Setting the vehicle systems » page 25 (not applicable for Yeti)
▶
- Activating/deactivating the Traffic Monitoring » page 14 (applies
to Yeti)
Touchscreen » page 9
SD card slot » page 16
Touch screen
The device is equipped with a touch screen that can be operated by light finger pressure on the screen surface.
The brightness of the screen can be set
→
Screen
→
Brightness:
.
CAUTION
■
The screen can only be operated by a slight touch of a finger. If there is too
much pressure there is a risk of damage to the screen!
■
To protect the screen, you can use a suitable screen protector for touch pads
that does not affect its functionality.
■
Dirt can be removed from the screen by using a soft cloth and, if necessary,
methylated spirits.
Software update
Current information on the compatibility of external devices can be found on
the following ŠKODAInternet pages.
http://go.skoda.eu/infotainment
▶
To display the software information, press the
button, then tap on the
System information
function surface.
▶
To start the software update, tap on the
Update software
function surface in
the displayed menu.
Turn device on/off
›
To power on/off the device, press .
Automatic Power On of the device
If the device was not switched off using the controller prior to switching off
the Ignition, this automatically switches on after the ignition is switched on.
6
7
8
Automatic Power Off of the device
If the vehicle key is pulled out of the ignition lock while the unit is switched on,
the device will switch off automatically.
If the vehicle is fitted with the starter button, the device will switch off automatically after the engine is switched off and the door is opened.
With the ignition off, the device will automatically turn off after about 30 minutes.
The device turns off automatically under certain circumstances. The device informs of this via a text message on the device display.
Adjusting the volume
Every change in volume is displayed on the screen.
›
To
increase the volume, turn the controller
clockwise.
›
To reduce volume, turn the controller anticlockwise.
›
To mute, turn the controller to the left to 0.
›
or: press the
button.
The following symbol appears in the display when the sound is muted .
If, at the time of muting, sound is played from the source in the media menu,
then the playback is interrupted (pause)1).
CAUTION
■
High volumes can cause sound resonance in the vehicle.
■
When changing or connecting an audio source, this may cause sudden
changes in volume. Reduce the volume before changing or connecting an audio source.
1)
Does not apply for AUX.
8
Introductory information