GB
General
Switching ON or OFF
Push the knob to switch the car radio on
or off. The unit switches on and operates at
the settings, such as treble, bass, balance,
etc., that were active prior to switching off,
with the exception of the volume, which is
reduced to switch-on level as selected in the
setup menu.
Adjusting the volume
When the radio is on, the knob On/Off
protrudes slightly from the front panel and
permits adjustment of the volume.
Adjust the volume by turning the knop
clockwise or counter-clockwise between
Vol 0 and Vol 45.
Sound adjustments
You are able to adjust the sound of your
car radio according to your preference.
Please note that the car radio permits and
stores separate adjustments for radio
reception and cassette operation.
To adjust the sound, proceed as follows:
Bass adjustment:
• Press the AUDIO button
AUDIO. The
display shows BASS with the currently
set value.
• Set the desired value between - 9 and + 9
by turning the knob
.
Treble adjustment:
• Press the AUDIO button
again (to
adjust the treble from normal operation,
press AUDIO twice). The display shows
TRE with the currently set value.
• Set the desired value between -9 and +9
by turning the knob
The radio stores the selected values and
returns to normal operation after pressing
button AUDIO
again or automatically 5
seconds after the last input.
Geometry (balance and fader)
The volume ration between the left and
right speakers is adjusted with the balance
function. The fader function is used to
adjust the volume ratio between the front
and rear speakers
To adjust the geometry, proceed as
follows:
Balance:
• Press the GEO button
. The display
shows BAL with the currently set value.
• Set the desired balance from LEFT 9 to
CENTER to RIGHT 9 by turning the knob
.
Fader:
• Press the GEO button
again (to adjust
the fader from normal operation, press
GEO twice). The display shows FAD with
the currently set value.
• Set the desired balance from REAR 9 to
CENTER to FRONT 9 by turning the
knob
.
The radio stores the selected values and
returns to normal operation after pressing
button
GEOagain or automatically 5
seconds after the last input.
5