Sklifeware LINKAGE SA200 Quick Manual

Basic Component

Hardware Icon Explanation

①

LINKAGE WiFi Speaker

②

DC Power Supply (100~240V/2A/9V)

①

②

LED Control Zone

⑥

Touch Panel

⑦

WiFi Key

⑧

Source Key

Input Terminal Zone

①

Micro SD Card Slot

②

AUX Input

③

External Power Supply

On/Off Zone

④

NFC Tag

⑤

Power Button

Two-Finger-Touch

Touch and

Swipe to the left

One-Finger-Touch

Long Touch

Short Tab

Touch and

Swipe to the right

Touch the LED panel with wet or damp ngers will cause

malfunction or incorrect results

Caution

①

⑥ ⑦ ⑧

④
⑤

② ③

PLAY

1. Play and Pause 2. Volume Control 3. Next/Previous Control

PLAY Volume Up Next

Volume Down PreviousPAUSE

Tap the touch panel to resume PLAY from PAUSE Touch and swipe the touch panel from left to right

with one nger

Touch and swipe the touch panel from left to right

with two ngers

Touch and swipe the touch panel from right to let

with one nger

Touch and swipe the touch panel from right to let

with two ngers

Tap the touch panel to PAUSE the PLAY

*

Note : Two-nger-touch is not activated in Direct Mode (Pink WiFi Key) such

as Miracast, WiFi Direct; AUX Mode (Orange Source Key); DLNA

*

Tips : Leave the nger on hold after swiping. The volume will automatically

volume up/down

USA CANADA

* FCC Information (For US customers)

IMPORTANT NOTICE:

DO NOT MODIFY THIS PRODUCT

• Model Number: SA200

• FCC ID : MBBSA200

This product, when installed as indic ated in the instructions contained in this manu al,

meets FCC requirements. Modification not expressly approved by Denon May void your

authority, granted by the FCC, to use the product.

CAUTION

• To compl y with FCC RF ex posure compl iance require ment, separa tion distance of at least

20 cm must be maintained between this product and all persons.

• This product and its antenna must not be co-located or operating in conjunction with

any other antenna or transmitter.

NOTE

This product has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This product

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will n ot occur in a particular installation.

If this product does cause harmful interference to radio or television reception, which can

be determined by turning the product OFF and ON, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the product into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the local retailer authorized to distribute this type of product or an experienced

radio/TV technician for help.

IC Information (For Canadian custo mers)

PRODUCT

IC No:11657A-SA200

This product complies with RSS-210 of Industry Canada. Operation is subject to the

following two conditions: (1) this product may not cause harmful interference, and (2)

this pro duct mu st acc ept any interf erence receive d, inc luding interference that may cause

undesired operation. This Class B digital apparatus complie s with Canadian ICES-003.

CAUTION

• To compl y with FCC RF ex posure compl iance require ment, separa tion distance of at least

20 cm must be maintained between this product and all persons.

• To reduce potential ra dio interference to other users, the antenna type and its gain

should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more

than that permitted for successful communication.

Informations sur IC (pour les clients ca nadiens)

APPAREIL

IC No:11657A-SA200

Cet appareil est conforme à la norme CNR-210 du Canada. L’utilisation de ce dispositif

est autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire de

brouillage, e t (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage

radioélectrique reçu, même si ce brouillage est susceptible de compromettre le

fonctionnement du dispositif. Cet appareil numérique de la classe B est conforme à la

norme NMB-003 du Canada.

ATTEN TIO N

• à Pour se conformer à la FCC RF e xigence de conformité de l'exposition, la distance de

séparation d'au moins 20 cm doit être maintenue entre ce produit et toutes les

personnes.

Ce produit et son antenne ne doivent pas être co-située ni fonctionner en conjonction

avec une autre antenne ou émetteur.

Afin de réduire le risque d’interférence aux autres utilisateurs, il faut ch oisir le type

d’antenne et son gain de façon à ce que la puissance isotrope rayonnée équivalente

(p.i.r.e.) ne soit pas supérieure au niveau requis pour l’obtention d’une communication

satisfaisante.

Quick Guide
for iPhone User

1. Connecting AirPlay

1-1. WiFi Enabled Zone

1-2. WiFi Unabled Zone

2. Connecting SD Card

3. Comprehensive Usage of LINKAGE

3-1. LINKAGE App Guide

3-2. Connecting Internet Radio

iOS version 7.0 or later is

required. Please download

LINKAGE application through

app store or LINKAGE

homepage

www.sklifeware.com/linkage

Press the WiFi key for
2 seconds

1. Connecting AirPlay

Please turn on the power button. Press the WiFi key for 2 seconds

until the blue LED right is blinking.

1-1. WiFi Enabled Zone

① Choose and select

accessible WiFi network from

WiFi setting.

Conneting WiFi