SKC IOM Calibration Adapter User Manual

Operating Instructions
863 Valley View Road, Eighty Four PA 15330
Tel: 724-941-9701 Fax: 724-941-1369
www.skcinc.com
Calidaptor
Cat. No. 391-01
To use the 391-01 Calidaptor with an IOM Sampler:
1. Push IOM through hinged bracket and place inlet against foam ring.
2. Clamp IOM in place with plastic clamping screw until foam ring compresses by 1 mm. Ensure IOM inlet is centered.
3. Screw supplied hose barb into threaded hole in calibration adapter inlet.
5. Connect IOM outlet to the inlet of a sample pump.
6. Adjust pump fl ow until desired fl ow reading appears on fl owmeter.
For additional information, contact SKC Technical Support
at skctech@skcinc.com
SKC is an ISO 9001 Registered Manufacturing Company
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which provides SKC’s sole liability and the buyer’s exclusive remedy. To view the complete SKC Limited Warranty and Return Policy , go to http://www .skcinc.com/warranty .asp.
Form 37144 Rev 1406