
4017
Aarhus Travel
AUFBAU & PFLEGE SET UP & MAINTENANCE
Wir freuen uns, dass Sie sich für ein Skandika-Zelt
entschieden haben. Es bietet Ihnen viel Platz und
Komfort in bekannt hoher Skandika-Qualität.
Bauen Sie das Zelt sicherheitshalber vor dem Urlaub
einmal zu Hause auf.
AUFBAUANLEITUNG
Bitte gehen Sie Punkt für Punkt vor, die Reihenfolge
ist wichtig.
• Gestänge und Zubehör: Entfernen Sie den kompletten Inhalt aus der Zelt-Tasche.
• Stecken Sie alle Zeltstangen vorsichtig zusammen.
• Breiten Sie die Zeltbodenunterlage und das Außenzelt auf einem möglichst glatten und sauberen
Untergrund aus.
AUSSENZELT
• Führen Sie jede Stange in einen Gestängekanal
des Außenzeltes vom einen Ende zum anderen.
• Stecken Sie die Metall Pins (zu fi nden an der unteren Kante des Außenzeltes) in beide Enden jeder
Zeltstange.
• Das Außenzelt steht jetzt von selbst und kann
durch Verankerung mittels der Stahlnägel gesichert werden.
• Die Spannung des Außenzelts kann durch die Abspannleinen und Schnallen reguliert werden.
INNENZELTE
• Bringen Sie das Innenzelt innerhalb des aufgestellten Außenzeltes an die passende Stelle.
• Beginnend von der Rückseite des Innenzeltes befestigen Sie die Ecken entlang der unteren Kante
des Außenzeltes.
• Haken Sie das Innenzelt an der Unterseite des
Außenzeltes ein beginnend von der unteren Rückseite and arbeiten Sie sich nach vorne vor unter
Benutzung der Clips auf der Außenwand des Innenzeltes and den entsprechenden Ringen an der
Unterseite des Außenzeltes.
Legen Sie die Überwurf-Konstruktion quer über das
Autodach und befestigen Sie diese mit den Abspannseilen an Ihrem Fahrzeug.
Thank you for choosing your new tent from the
Skandika range. It provides you with a lot of room
and high level of comfort in the well-known superior
quality of Skandika.
Before you go on holiday with the new tent, please
do a test set-up.
ASSEMBLY INSTRUCTIONS
Please follow these instructions point by point in the
given order.
• Poles and components: Remove all contents from
tent bag.
• Extend all tent poles carefully. Do not let the
shock cords snap the poles together.
• Unfold inner tent and rain fl y and lay on ground.
RAIN FLY
• Insert each pole into 1 sleeve of the fl y from one
end to the other.
• At the end of each tent pole, insert the metal pins
(found along the bottom edge of the rain fl y) into
both ends of each tent pole.
• The rain fl y is now standing up by itself, which can
be secured by anchoring down with steel stakes
at the PP webbings, located at the edges of the
fl y .
• Tension of the fl y can be adjusted by the guy ropes and buckles on the PP webbings joining both
sides of the fl y.
INNER TENTS
• Take the inner tents inside the assembled rain fl y
to its appropriate location.
• Starting from the rear of the inner tent, stake
down the corners along the bottom edge of the
rain fl y.
• Hook the inner tent to the underside of the rain fl y
starting from the bottom rear and work your way
forward to the top using the toggles on the outer
wall of the inner tent and loops running along the
underside of the rain fl y.
The tent has a throw-over construction. Simply throw
the material over the parked car and fasten the tension
guylines at your vehicle.
MONTAGE & ENTRETIEN
Nous nous réjouissons que vous ayez choisi une
tente SKANDIKA. Ces tentes off rent beaucoup
d’espace et de confort et ceci en qualité supérieure
marque Skandika.
Pour ne pas courir de risques nous vous conseillons
de faire un essai de montage de la tente avant de partir en vacances.
MONTAGE
Veuillez procéder point par point, l’ordre des diff érentes étapes est important.
• Système de tiges et accessoires : Veuillez sortir le
contenu complet de la tente du sac.
• Assembler prudemment toutes les barres de tente.
• Ètalez le tapis de sol de tente et le tapis de
l’extérieur sur un sol lisse et autant que possible
propre.
TENTE EXTÉRIEURE
• Conduisez chaque barre dans un canal de tige de
la tente extérieure.
• Mettez les goupilles ( se trouvant au bord inférieur de la tente extérieure) en métal dans les deux
fi ns de chaque barre de tente.
• La tente extérieure est maintenant mis en place et
peut être fi xée au moyen des clous sidérurgiques.
• La tension de la tente extérieure peut être réglée
par les lignes d‘élimination et les boucles.
TENTES INTÉRIEURES / CABINES
• Installez la tente à l‘intérieur convenablement á la
tente extérieure.
• Commençant du dos vous attachez de la tente de
l‘intérieur au coins se trouvant le long du bord inférieur de la tente extérieure.
• Accrochez la tente de l‘intérieur au dessous de
la tente extérieure commençant du dos inférieur
ainsi vous travaillez en avant tout en utilisant des
Clips de la paroi externe de la tente à l‘intérieur
les anneaux correspondants au dessous de la tente extérieure.
Deployez la bâche restante par-dessus le toit du véhicule et fi xez la au véhicule à l‘aide des cordages.
WICHTIG
Wenn Sie Schwierigkeiten bei einem der Schritte haben, besuchen Sie bitte unsere Zeltaufbau-Video Seite, die Bilder und Tipps für jeden Schritt bereit hält.
Sollte noch etwas unklar sein, kontaktieren Sie uns
bitte unter
[email protected].
PFLEGE
• Das Zelt muss beim Aufbau und Zusammenfalten
völlig trocken sein. Ansonsten besteht Verschimmelungs- und Verrottungsgefahr.
• Heringe und Nägel sollten immer getrennt von
Außen- und Innenzelt verpackt werden.
• Die Bodenwanne des Innenzeltes sollte vor dem
Zusammenfalten gereinigt werden.
• Schmutz an der Zeltwand entfernen Sie bitte
ausschließlich mit einem weichen Schwamm und
klarem Wasser. Verwenden Sie keine Reinigungsmitte, da diese der Imprägnierung schaden können.
• Ziehen Sie Heringe und Nägel nicht an den Ringen bzw. Abspannleinen aus dem Boden.
BRAUCHEN SIE HILFE?
Sehen Sie sich unsere Aufbau-Videos mit einer
visuellen Schritt-für-Schritt-Präsentation an,
die sie beim Aufbau begleiten.
www.skandika.com/zeltaufbau
IMPORTANT
If you have diffi culty with any step, please visit our
tent set-up video page below which gives imagery and
tips for each step.
If anything is still not clear then please feel free to
contact us at
[email protected].
CARE
• When packing the tent make sure that it is completely dry, otherwise there is a danger of mildew
and rotting.
• Always pack poles and tent pegs separately from
inner and outer tent.
• Prior to folding, clean the basement of the inner
tent.
• Use a soft sponge and clear water only to clean
the outer tent canvas. Don‘t use any cleaning
agent, for they may be harmful to the impregnation.
• Never pull tent pegs out by means of rings or tensioning ropes.
NEED HELP?
See our set-up videos with a step by step
visual presentation to guide you along.
www.skandika.com/tentsetup
IMPORTANT
Si vous avez des diffi cultés à n‘importe quelle étape,
veuillez consulter notre page vidéo de montage de
tente ci-dessous qui donne des images et des conseils
pour chaque étape. Si toutefois quelque chose n‘est
toujours pas clair, n‘hésitez pas à nous contacter à
[email protected].
ENTRETIEN
• Lors du démontage et pliage, prendre le temps de
sécher chaque élément afi n d’éviter toute moisissure et décomposition.
• Toujours ranger les pointes et sardines séparément des toiles intérieures et extérieures.
• Nettoyer le fond de la tente intérieure avant de
la plier.
• Nettoyer d’éventuelles salissures sur la tente à
l’aide d’un linge doux et de l’eau claire. Ne pas
utiliser de détergent car ceci pourrait détériorer
l’enduction protectrice.
• Ne pas tirer sur les cordes d’ancrage pour extraire
les sardines et pointes du sol.
BESOIN D‘AIDE ?
Visionnez nos vidéos d‘installation avec une
présentation visuelle étape par étape pour vous
guider.
www.skandika.com/montagetente