Sixth Sense CTR2000 Data sheet

CTR2000 COUNTER SERIES
HIGH-PERFORMANCE MULTI-FUNCTION COUNTERS
The CTR2000 Series Counters have been designed to handle a broad range of the toughest engineering applications. The series
consists of five models: the CTR2000 Preset Totalizer, the CTR2001 Preset Rate Counter, the CTR2002 Preset Batch/Dual Counter,
the CTR2003 Preset Rate/Totalizer, and the CTR2004 Frequency Counter.
Each model fits a 1/8 DIN cutout and is perfect for tight spaces, extending only 3.24” behind the front panel. A NEMA 4X/IP65 rated
be used for future increased capability. Models CTR2000, CTR2001, CTR2002 and CTR2003 have front-panel programming using a
large-button, audible and tactile feedback keypad. The programming menu is designed to be easily used and understood, using a
menu made of words, not hard-to-understand symbols or codes. Easy-to-read 6-digit, bright red 0.56” LED display provides high
visibility and wide-angle viewing. The CTR2004 Frequency Counter has a 4-digit display with no keypads.
The counters are powered from 120 or 240 VAC and have a non-volatile EEPROM to retain all programming and count information
when the power source is interrupted. All models accept pulses from different types of sensors including Quadrature, CMOS or TTL
circuits, and PNP or NPN devices. The optional 12VDC (100mA) excitation output module can provide power for external sensors.
• The CTR2000 Preset Totalizer can be adapted to a wide variety of counting, measuring and controlling applications. It offers
several counter operation modes: count/direction, add/add, add/subtract, subtract/subtract, quadrature and reverse quadrature.
Optional relay outputs enhance the counter from a passive device to an integral control element for your application.
• The CTR2001 Preset Rate Counter is typically used in applications involving speed and is capable of counting in four different
time modes: hours, minutes, seconds and milliseconds(msec). The msec rate mode increases the frequency resolution to 0.001Hz
within a range of 1 to 999.999 Hz. Some examples are feet per minute, revolutions per minute, pulses per second, and gallons
per minute.
• The CTR2002 Preset Batch/Dual Counter is a multi-function counter that can be easily configured to operate either in a dual mode
or in a totalizing/batch mode. In both modes, each display has separate scaling and reset functions. When programmed to
function in the dual mode, full direction control is maintained for totalizing and batch counts. In the totalizing/batch mode, the
secondary value (batch count) is incremented only after the primary totalizing count has completed its cycle.
Example: one case = 24 cans.
• The CTR2003 Preset Rate/Totalizer is a multi-function counter that allows the user to track the rate (speed) of a product and
continuously monitor the product quantity for a given process. The count and rate displays have separate programmable decimal
point settings and scaling values. The CTR2003 supports two independent output channels with four modes of operation:
disabled, timed, latched and boundary. Both channels can be reset simultaneously or independently of each other.
• The CTR2004 Frequency Counter offers a wide frequency range from 1Hz to 35KHz with four display ranges: 9.999Hz, 99.99Hz,
999.9Hz and 35KHz. It offers 12VDC, 100mA sensor excitation and requires no programming. Selecting the appropriate frequency
range is the only set-up required.
• Five Different Models
Preset Totalizer, Rate, Batch/Dual, Rate/Totalizer, and Frequency
• Easy to Configure
Menu-driven from the front panel
• Easy to Read
6-digit, bright red 0.56” LED display
• Easy to Use
Large buttons with tactile and audible feedback
• Rugged and Durable
NEMA 4X/IP65 panel for harsh environments
C
Information subject to change without notice. Prices in USD.
CTR2000, CONTINUED
SPECIFICATIONS
GENERAL SPECIFICATIONS
INPUT RATINGS Current Sinking: 10K, 5% Res. pull-up resistor to
(9.0 - 16 VDC) ±10% Current Sourcing: 5.1K, 5% Res. pull-down resistor to common Minimum Pulse Width: 5ms Low Pass Filter: ≈200Hz Low Bias: VLT = 1.6V ±10% VUT = 3.6V ±10% High Bias: VLT = 5.0V ±10% VUT = 7.0V ±10% Count Rate: 20KHz (Pulse Max). 7.5KHz (Quadrature X4 Max) Maximum Voltage Input: A, B, and User – 30 VDC (Max)
INPUT Standard Input: VLT = 0.2 VDC guaranteed low
Quadrature Input: VLT 0.9 VUT 3.15VDC User Input: Display is frozen and input signal is ignored when User input is pulled low
REMOTE RESET Resets the counter from the rear terminals
VLT 0.2 VDC guaranteed low (Not available on CTR2004)
CONTROL OUTPUTS Relays: Rated at 5A, 250 VAC or 30 VDC
Output Response Time: Latched and Timed modes < 5ms. Boundary mode < 15ms (Not available on CTR2004)
DISPLAY Type: 6-digit, 7-segment, red LED
Height: 0.56 in. (14.2 mm) Decimal Point: User programmable Count Direction: “+” indication implied, “-” indication displayed Display Range: -99,999 to +999,999 Output Indicators: 1 and 2
COUNT INPUTS SUPPORTED Types: Quadrature, switch, TTL, CMOS, NAMUR,
TTL, PNP and NPN
EXCITATION Excitation: Isolated 12 VDC @ 100mA
Excitation Isolation: 1500V Voltage Regulation: ±5%
POWER REQUIREMENTS AC Voltages: 120, 240 VAC, ±10%
Power Consumption: 3VA
OPERATING AND STORAGE CONDITIONS
OPERATING TEMPERATURE 32 to 131°F (0 to 55°C) STORAGE TEMPERATURE 14 to 140°F (-10 to 60°C) RELATIVE HUMIDITY 0-85% non-condensing TEMPERATURE ±100 ppm/°C
COEFFICIENT (PER °C)
STRUCTURE
BEZEL 3.93 x 2.04 x 0.52 in. (99.8 x 51.8 x 13.2 mm) DEPTH 3.24 in. (82 mm) PANEL CUTOUT 3.62 x 1.77 in. (92 x 45mm) 1/8 DIN
CTR2000 ORDERING INFORMATION
C T R 2 0 0 A B C D E
To create a part number fill in the boxes above with the appropriate number and/or letter from the corresponding box below.
Box A: Basic Unit
0 = Preset Totalizer $ 169 1 = Preset Rate 169 2 = Preset Batch/Dual 199 3 = Preset Rate/Totalizer 199 4 = Frequency 135
Box B: Power Supply
1 = 120 VAC N/C 2 = 220 VAC N/C
ACCESSORIES
CTR-12VDC Excitation Module $ 25
CTR-RLY1 Single Relay card 25
CTR-RLY2 Dual Relay card 40
Box C: Input Type
1 = Standard Input N/C 2 = Quadrature Input $ 55
Box D: Output Type
0 = None N/C 1 = Single-Relay card 25 2 = Dual-Relay card 40
(Not available with CTR2004)
Box E: Excitation Output
0 = None N/C 1 = 12 VDC 25
Information subject to change without notice. Prices in USD.
Loading...