Sitecom MD-500, MD-270 Wireless Connection Manual

TV Media Player

Wireless Connection Manual

Wireless Connection Manual

Revision 1.0

Table of Contents

1. Start the Wizard ................................................................................................ 3

2. WPS Push Button ............................................................................................... 5

3. WPS PIN........................................................................................................... 7

4. Manual Connect – Site Survey........................................................................... 10

5. Manual Connect – Manual SSID ......................................................................... 13

6. Wireless Favorites............................................................................................ 16

1. Start the Wizard

To configure your TV Media Player for a Wireless Connection, you need to insert the
Sitecom Wireless Media Adapter 300N into one of the USB ports on your TV Media Player.

Then you need to start the Network Configuration Wizard. This wizard is automatically
started when you start the TV Media Player up for the first time, but can also be accessed
from the Settings menu. Go to Settings -> Network and select “Configure Network” to
start the wizard.

Select “Next” to start the wizard.

You can choose from 3 different connection methods, which are described in the next
chapters.

2. WPS Push Button

Select “WPC PBC mode” if you want to make use of the WPS Push Button for the
connection. If your router has a WPS button, please press it now. Refer to the manual of
your router for the proper procedure. Afterwards, please select “CONNECT” on the
screen, or press the button on top of the Sitecom Wireless Media Adapter 300N that’s
connected to your TV Media Player.

You’ll see the screen below.

The WPS connection is now being established. After a while you’ll see the screen below.

Select “Auto” if your router has a DHCP server. This is the option that you should
normally choose. Select “Advanced Setup” if you want to manually assign an IP-
address to the TV Media Player. Please refer to page 30 of the TV Media Player Manual
for the steps to manually assign an IP-address.

The next screen appears.

The wireless connection is now being established. After a while you’ll see the screen
below.

You have successfully set up your device for your home network. Select “Finish” to exit
the Wizard.