SISTEMATICA S p A RTXTRENDLCD User Manual

TRENDRTX WITH DISPLAY

RADIO REMOTE CONTROL TRANSMITTER

USER AND MAINTENANCE MANUAL

WARNINGS

This manual is an essential part of the device and it should be thoroughly kept for later consultation.
Carefully read the warnings contained in this manual, concerning safety and a proper preservation of the
product. These warnings are ALWAYS to be carefully read before using the device. SISTEMATICA S.p.A.
declines all responsibility for any trouble arising from the non-compliance with these warnings.

• AVOID ATTEMPTING TO REPAIR THE DEVICE BY YOURSELF. REPAIRS PERFORMED BY

UNSKILLED PEOPLE CAN CAUSE SERIOUS DAMAGES OR FAILURES. FOR ASSISTANCE,
APPLY TO YOUR LOCAL AUTHORIZED SERVICE CENTRE. USE ONLY ORIGINAL SPARE PARTS.

• ALWAYS KEEP AT A SAFE DISTANCE FROM THE MOVING PARTS.

• KEEP THE RADIO CONTROL OUT OF THE CHILDREN’S REACH.

SISTEMATICA S.p.A. REV.1

Via S. Pertini, 17 – 12030 MANTA (CN) ITALY Tel. [phone] r.a. – Fax [phone]

http://www.sistematica.it e-mail: [e-mail] 12/04/2012

• Manufacturer: SISTEMATICA S.p.A.

• Dimension (in mm): 180 x 78 x 40

• IP protection: IP67

• Operating temperature: -20°C ÷ +70°C

• Battery supply: lithium polymer batteries (Li-Pol)

single cell 3,7V 1200 mAh

• Quiescent absorption: 20 µA

• Active and passive Safetypoint

The transmitter is equipe with a meduse to indicate the charge status of the system. The following table descrive the
meaning:

Coding the system is an operation that is only necessary when the receiver has to be replaced or you want to use it
with a different SISTEMATICA radio remote control from the one it is coupled with at the time of purchase.

To recode the system, consult the user manual of the receiver coupled with the transmitter.

The cradle (battery charger interface) has to be installed less to 1 meter far from the vehicle cigarette lighter socket.
Since it is provided with a standard vehicular battery charger with 1m cord.
To power the cralde:

- insert the battery charger in the cigarette lighter socket

- plug the battery charger micro-USB output connector into the cradle micro-USB socket
The cradle can be powered with any standard vehicular battery charger with mirco-USB output connector.

The remote control is equipped with a single cell Li-Po battery which can be recharged without the need to remove it

BATTERY MANAGEMENT AND RECHARGE

from the device.
During the use of the remote control, an icon on the display indicates the status of the battery through four
segments.
The charge process start automatically once the remote control is placed in its cralde, the battery icon, together with
the red led indicate that the charge is in progress.
Once the charge is complete the battery icon indicates the complete full battery status and all the four segments of
the battery icon are lighted.

TECHNICAL FEATURES

• Keyboard (2 possibilities – both with backlight)

- 8 keys

- 4 keys + 4 joy-pad keys

• 3-axis accelerometer for tilting-hand

• Buzzer

• Display 128x128 COG-FSTN blue backlight

• Working distance: 100÷150 m in free fiel condition

• CRADLE – battery charge

TRANSMITTER LED

LED FUNCTION MEANING

RED ON Transmitter in charge

SYSTEM CODING

CRADLE INSTALLATION

Figura 1. Palmare in carica

SISTEMATICA S.p.A. Pag. 2/3

Via S. Pertini, 17 – 12030 MANTA (CN) ITALY Tel. [phone] r.a. – Fax [phone]

http://www.sistematica.it e-mail: [e-mail]

PRODUCT IDENTIFYNG LABELS

INTERNAL EXTERNAL

TREND LCD: product model

Product serial number

P

ROBLEM

P

PROBLEM IDENTIFICATION AND SOLUTION

OSSIBLE CAUSES

Flat batteries

to the control

Declaration of conformity for Sistematica S.p.A. products can be required at: [e-mail]

This product may be subjected to usage restriction. Please contact [e-mail] for any further questions.

These devices complies with Part 15 of the FCC rules.

System not coded

CE MARK

FCC STATEMENTS

S/N: product serial number

Cod.: product identification number

S

OLUTIONS

-Charge the battery (see “BATTERY
MANAGEMENT AND RECHARGE”) The system does not respond

-Re-code the system (vedi “CODIFICA DEL
SISTEMA”)

Operation is subject to the following two conditions:
(1) these devices may not cause harmful interference and
(2) these devices must accept any interference received, including interference that may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to
these equipment. Such modifications could void the user’s authority to operate the equipments.

SISTEMATICA S.p.A. Grantee Code: O8I

TRENDRTX LCD label example
FCC ID: O8IRTXTRENDLCD

SISTEMATICA S.p.A. Pag. 3/3

Via S. Pertini, 17 – 12030 MANTA (CN) ITALY Tel. [phone] r.a. – Fax [phone]

http://www.sistematica.it e-mail: [e-mail]