Sirius Satellite Radio ECD-T1540 User Manual

ECD-T1540

SIRIUS SATELLITE RADIO OPERATING MANUAL

VOLUME

S-MOD

SAT

LOUD / ENTER

Full Panel Detachable High Power FM/AM Stereo Receiver Compact Disc Player ISO Mounting with Removable Trim Ring Sirius Function Remote Control Ready CD-R/RW Compatibility

P. S C A N

45W x 4

MANU/SKIP

(English)

SIRIUS OPERATION……………. 2~3

SIRIUS OPERATION

S-MOD

VOLUME

SAT

LOUD/ ENTER

P. S CA N

45W x 4

MANU/SKIP

768

SWITCHING TO SIRIUS MODE……………………..…(1)

Press MOD button (1) to select Sirius mode.

SELECTING USER-PRESET CHANNEL……………..(2)

At Sirius mode, the Sirius user-preset channel group (3 groups) is toggled cyclically through the

group by quickly pressing the BND/LOUD/ENTER button (2).

The channel will change in the following order:

SR1 SR2 SR3

SELECTING CHANNEL UP/DOWN……………………(3)

Press the MANU/SKIP or button (3) to select the channel up or down.

SEARCHING STATION…………………………….……(4)

When the AS/PS/P.SCAN button (4) is pressed, the channel searches for each user preset

station from SR1 to SR2 to SR3.

When an available channel is detected, the station will be held at that preset number and play for

5 seconds. After that, it will mute and search for another available station

STORING PRESET STATIONS .................................(8)

The preset buttons (8) can be used to store 6 stations for convenient access to your favorite

stations.

• Programming stations ..... 1. Select the desired station you want to store in memory.

2. Press and hold one of the preset buttons (8) for more than 2

seconds until the corresponding preset button number appears.

Repeat steps 1. and 2. to program additional stations.

• Quick tuning .................... Press one of the six preset buttons 8 shortly to select a preset

station directly.

SIRIUS MODE SELECTION ...........................…..(5)

Press LOC/S-MOD button (5) to switch Category mode, Skip mode or normal. It is used as the

selection of each:

Normal Category mode Direct Tune Skip Channel mode

When Category mode or Skip mode is engaged, the “CATEGORY” or “SKIP” function is turned

on in the display. When Category mode or Skip mode is released, the “CATEGORY” or “SKIP”

function is turned off. When Direct mode is engaged, “DIRECT” of alphanumeric display is turned

on.

Select Category and TUNE UP/DOWN within selected Category

Use CAT button (7) or CAT button (6) to select desire Category and press

BND/LOUD/ENTER button (2).

In Category mode, stations can be tuned within the same category.

- When the user wishes to search by Category, press LOC/S-MOD button (5) can be pressed

until it goes into Category search mode.

- Press CAT

- To change channels, press LOC/S-MOD button (5) again to Normal mode, and then press

MANU/SKIP

button (7) or CAT button (6) up and down to get to the desired category.

or button (3) to select the channel up or down.

The operation of skip channel function

In Skip mode, pressing LOC/S-MOD button (5) for more than 3 seconds sets the SKIP channel

mode. Details for set or release skip channel is as follows.

Use MANU/SKIP

sequentially.

- Press BND/LOUD/ENTER button (2) to select skip or release the following channel. (If the

channel was skipped, the “SKIP” icon will be displayed.

- Press LOC/S-MOD button (5) for more than 3 seconds again to return to basic mode

automatically after 10 seconds.

Note:

In skip mode, use MANU/SKIP or button (3) to show skipped channels.

or button (3) to be switched to SKIP channel set or release mode

How to direct tune

1. In direct mode, display shows DIRECT and “000” channel number. (Hundred Digit flashing

on/off)

2. Use MANU/SKIP

3. Press LOC/S-MOD button (5) again to confirm entry of the hundred digit and the 10s digit is

flashing on/off.

4. Use MANU/SKIP

5. Press LOC/S-MOD button (5) again to confirm entry of the 10s digit and the 1s digit is

flashing on/off.

6. Press LOC/S-MOD button (5) again to confirm entry of the 1s digit.

or button (3) to select hundred digit.

or button (3) to select 10s digit.

7. Press BND/LOUD/ENTER button (2) to direct tune.

MANU/SKIP

45W x 4

LOUD/

ENTER

SAT

ECD-T1540

VOLUME

S-MOD

P.SCAN

Full Panel Detachable High Power FM/AM Stereo Receiver Compact Disc Player ISO Mounting with Removable Trim Ring Sirius Function (see separate booklet on Sirius Radio operation) Remote Control Ready CD-R/RW Compatibility

(English)

OPERATING INSTRUCTIONS……………. 2~24

CONTENTS

COMPACT DISC CARE .................................................................................................. 3

DIGITAL DISPLAY ........................................................................................................... 4

DETACHABLE FRONT PANEL ......................................................................................... 5

GENERAL OPERATION...................................................................................................6

RADIO OPERATION........................................................................................................ 8

CD OPERATION .............................................................................................................. 10

CDC OPERATION ............................................................................................................ 12

AUX MODE OPERATION ................................................................................................. 14

REMOTE CONTROL READY ........................................................................................... 14

ERROR SIGNS ................................................................................................................ 15

HINTS FOR PROPER AND SAFE OPERATION................................................................ 16

TROUBLE SHOOTING..................................................................................................... 17

ACCESSORIES AND HARDWARE ................................................................................... 18

INSTALLATION................................................................................................................ 18

UNIT REMOVAL .............................................................................................................. 19

ELECTRICAL CONNECTIONS......................................................................................... 20

LINE OUT CONNECTIONS .............................................................................................. 22

AUXILIARY INPUT CONNECTIONS ................................................................................. 22

CAUTION

• This unit is designed to operate on 12 volts DC, NEGATIVE ground electrical systems only.

• When fuse replacement is necessary, use only a 15 amp fuse. Do not replace with a higher rated fuse. If the fuse blows often, carefully check all electrical connections for any short circuits and have your car’s voltage regulator checked also.

• Do not install the unit where it will be exposed to direc t sunlight or hot air discharged from the car heater.

• Do not expose the unit to water or moisture.

• To avoid damaging the unit, never insert anything other than a compact disc into the disc slot.

• This unit should not be adjusted or repaired by anyone except qualified service personnel. If servicing is required, return the unit to an authorized SANYO mobile audio dealer.

• Use the Controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

• Changes or modifications not expressly approved by SANYO may void the user’s authority to operate this equipment.

COMPACT DISC CARE

surface of the disc.

temperatures

for extended periods of

time.

Recommended CD

-R/RW

Media

ReWritable

Dirt, dust, scratches and warpage can cause a deterioration in the sound or intermittent skipping some tracks during play.

TEXT

• This unit has been designed to play compact discs bearing the identification logo shown the left. No other discs can be played.

• Do not use non-conventional discs such as heart- shaped, octagonal discs, etc. The player could be damaged.

Data may not be properly written to CD-R/RW media depending on the quality of the media. If this happens, the data may not be reproduced correctly. We recommend the following manufacturers to insure proper quality of the media.

CD-R Media

TDK USA Corp., Taiyo Yuden (U.S.A.), Inc., Ricoh Corporation, Eastman Kodak Company, Maxell Co rporation of America, Mitsubishi Chemical Corporation, Fuji Photo Film U.S.A., Inc., Mitsui Chemicals, Inc., Sony Corporation of America, Philips Electronics North America Corporation, Imation Corp.

CD-RW Media

TDK USA Corp., Ricoh Corporation, Mitsubishi Chemical Corporation. Additionally, CD-R media compatible with various speeds such as 2X and 1X-4X are

available. Please refer to the instruction manuals of the drive and the recording software you are using to selection of the correct media.

• Fingerprints and dust should be carefully wiped off the signal surface of the disc (glossy side) with a soft cloth. Wipe in a straight motion from the inside to the outside of the disc. Unlike conventional records, the compact disc has no grooves to collect dust and debris. Small dust particles will have no effect on reproduction quality.

• Do not insert a disc which is cracked into the unit.

• Do not apply paper or write anything on the

• To prevent warping the disc, do not expose it to direct sunlight, high humidity or high

• Never use chemicals such as record cleaning sprays, antistatic sprays or fluids, benzene or thinner to clean compact discs. These chemicals will permanently damage the plastic surface of the disc.

• When not using the disc player for extended periods of time, remove the compact disc and return it to the plastic storage case. This will protect the disc from dust and exposure to

the sun.

DIGITAL DISPLAY

Radio Frequency, Time, CD

Track Number, Audio Control

Artist

CD-IN indicator

Channel name indicator

CLASSIC

SAT

POP Channel name

ROCK

Selected Mode

SAT

Stereo Local

Category Mono

Skip

Loud Song title

DETACHABLE FRONT PANEL

The unit wi

ll not operate if

panel

is installed incorrectly.

The front panel is designed to be removable for antitheft purposes. It is recommended that you remove and carry the front panel with you when you leave your car.

HOW TO ATTACH THE FRONT PANEL

Align the right side of the panel (A) with the stopper (B), and then push the left side of the panel into the unit until it clicks.

HOW TO DETACH THE FRONT PANEL

Press the release button (REL) to release the front panel. Pull the entire panel to remove it from the unit.

RETURNING TO THE INITIAL SETTINGS

When the front panel is detached, you can find the RESET button on the front side of the unit. Press the button, the Microcomputer of the unit returns to the initial settings. If the display window is not properly shown or the unit malfunctions, press the RESET button.

Note

A B

REL button

RESET button

CAUTION

• Do not attempt to remove the panel in a manner other than that described above.

• When installing the panel, do not force it into the unit.

• Do not touch the connection terminals of the panel or the unit. It may cause poor contact.

• Use a clean, dry cloth when cleaning the terminals.

• Keep the panel out of direct sunlight and high temperatures.

• Prevent the panel from coming into contact with benzene, thinner, or insecticides.

• Do not drop the panel.

GENERAL OPERATION

5108

674

MANU/SKIP

45W x 4

LOUD/

ENTER

SAT

VOLUME

S-MOD

P.SCAN

TURNING THE POWER ON........................Any button

Install the front panel and press any button (except and button) when ACC is on.

TURNING THE POWER OFF ...............................… .. (1)

When system is on, press the POWER button (1) to turn off the unit.

VOLUME LEVEL CONTROL....................................... (2)

Rotate the VOLUME dial (2) to adjust the volume level.

ADJUSTING THE SOUND

CHARACTERISTICS ..................................… ......(2), (3)

Press the SEL button (3) shortly:

1. Each time you press the SEL button (3) shortly, the item changes as follows; VOL BAS TRE BAL FAD

(Volume) (Bass) (Treble) (Balance) (Fader)

2. Rotate the VOLUME\CH-SEL dial (2) to adjust the selected item. Make the adjustment within

5 seconds after selecting. After 5 seconds, the display window will revert to display priority.

Adjustment Range

BASS (BAS 00) BAS –10 BAS 10 TREBLE (TR B 00) TRB –10 TRB 10 BALANCE (BAL L=R) 10L 10R FADER (FAD F=R) 10F 10R

Beep Sound Adjustment:

Press and hold the SEL button (3) for several seconds to enter beep sound adjustment mode, then rotate the VOLUME dial (2) clockwise or counter-clockwise to select as follows:

BEEP 2ND BEEP ALL BEEP OFF

- BEEP 2ND mode:

The beep is only gen erated when all allowed double function button is pressed for several seconds.

+ 19 hidden pages