Sirius warranty covers only Sirius product. If you choose to install a non-Sirius branded accessory
such as flexible ducting, Sirius will only warrant the hood and motor. If installation is found to be the
cause of failure or issue then charges will apply for service and parts.
Flexible ducting is not permitted under any circumstances. Flexible ducting has been found to
increase noise levels, increase vibration and reduce airflow.
Sirius Semi-rigid or solid ducting can be used in lieu.
There is a range available to suit any application.
BEFORE YOU INSTALL
TO THE ATTENTION OF THE USER
PRE-INSTALLATION CHECKS
INSTALLATION INSTRUCTIONS
TOP CEILING BRACKET TEMPLATE
FITTING THE FLUE COVER
EXTENDING THE FLUE COVER
WARRANTY
10
10
3
4
The appliance must be installed and
5
6
7
8
• There shall be adequate ventilation of the room when the range hood is used at the same time as
appliancess burning gas or other fuels (not applicable to appliances that only discharge the air back into
the room)
• The details concerning the method and frequency of cleaning
• There is a fire risk if cleaning is not carried out in accordance with the instructions;
• Do not flambé under the range hood;
• CAUTION: Accessible parts may become hot when used with cooking appliances.
A reduction in the duct diameter from stated ducting size will void warranty.
If you are in doubt about the ducting, please contact Sirius on 1300 762 219 prior to installation
connected to the power supply only by a
Ducting available at www.siriusbrand.com
WARNING
qualified technician.
The symbol on the product or on its packaging indicates that this product
may not be treated as house-hold waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly,
you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed information about
recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased the
product. This appliance is marked according to the European directive
2002/96/EC on waste electrical and electronic equipment (WEEE).
23
Page 3
TO THE ATTENTION OF THE USER
This rangehood is designed to work with ducted
outside evacuation.
WARNING
Keep these instructions for use with the appliance. If
the appliance should be sold or passed on to others,
make sure that the instructions are passed on with
it. We thank you for taking note of these suggestions
before installing and using the appliance. They have
been written for your personal safety and the safety
of others.
SAFETY INSTRUCTIONS
These hoods have been designed for personal
use in the home. The appliance must be used by
adults. Make sure that the appliance is out of reach
of children and that they do not use it to play with.
Make sure that children do not operate the controls.
• When the appliance is delivered, check the overall
appearance of the packaging.
• Any remarks should be written on the delivery
invoice, of which you keep a copy.
Your appliance is designed for normal domestic
use. It is not designed for commercial or industrial
use, or for purposes other than those for which it
was designed.
• Any consequences of or damage from incorrect
installation or incorrect use of the appliance will
not be covered by the manufacturer’s guarantee.
• Do not ever change or try to change the
characteristics of this appliance. This would be
a danger. Repairs must be performed only by an
authorised technician.
• Always disconnect the hood before carrying out
cleaning or maintenance operations.
• Adequately ventilate the room when a rangehood
and other appliances, powered by energy other
than electricity, are used simultaneously, so that
the hood does not suck any combustion fumes.
• It is not allowed to cook food over open flames
(flambé) or operate gas hobs without pots
or pans on them under the hood itself (the
flames sucked into the hood might damage the
appliance).
• Frying under the appliance must be done under
constant supervision as hot oils and fats may
ignite.
• Respect the guidelines for cleaning and
replacement of grease filters. Accumulated
deposits of grease are a fire hazard.
• This appliance must not be used over cook tops
powered by wood or coal or in any case, over
cook tops with power levels that could damage
the appliance.
• Never use steam or high-pressure devices
for cleaning your hood (regulations regarding
electrical safety).
• Never use the rangehood without the grease
filters.
At Sirius, we are constantly seeking to improve
our products. We reserve the right to modify their
technical, functional, or aesthetic characteristics
deriving from their upgrading.
Motors manufactured and approved by Sirius only
are to be used at all times. Failure to comply with this
will result in the forfeit of the manufacturer warranty.
The air collected must not be conveyed into a flue
used for smoke or fumes from appliances powered
by anything other than electricity (central heating
systems, bathroom and toilet exhausts, etc.). As
far as discharging exhaust air is concerned, please
follow the guidelines given by competent authorities.
PRE-INSTALLATION CHECKS
Connect all of the electrical components to the unit and motor to make sure both the unit and the motor are
functioning properly.
CAUTION
Installation must comply with the regulations in force regarding the ventilation of enclosed environments.
In particular, discharged air must not be conveyed into a duct used for fumes discharge or discharge from
appliances using gas or other combustible materials. Air cannot be ducted into roof space.
The use of discontinued ducts is not allowed without the approval of a qualified technician.
BEFORE YOU INSTALL
Sirius warranty covers only Sirius product. If you choose to install a non-Sirius branded accessory such as
flexible ducting, Sirius will only warrant the hood and motor. If installation is found to be the cause of failure or
issue then charges will apply for service and parts.
Flexible ducting is not permitted under any circumstances. Flexible ducting has been found to increase noise
levels, increase vibration and reduce airflow. Sirius Semi-rigid or solid ducting can be used in lieu. There is a
range available to suit any application.
Available at www.siriusbrand.com
A reduction in the duct diameter from stated ducting size will void warranty.
If you are in doubt about the ducting, please contact Sirius on 1300 762 219 prior to
installation.
45
Page 4
INSTALLATION INSTRUCTIONS
Ensure that there are support beams in the ceiling cavity to support the weight of this rangehood.
CAUTION
Under no circumstances is this rangehood to be suspended from plaster only as it will not support
the weight of the rangehood.
TOP CEILING BRACKET TEMPLATE
(50% SCALE)
290 mm
1. Find the exact centre in the ceiling so the hood
will be directly over the top off the barbecue
grills/plates.
2. Prepare the top mounting bracket (Fig. 1) holes
by using the bracket itself as a template. This
bracket is held in place by the supplied
6 x 40mm screws and plastic dowels.
Pre-drill the holes in the timber support beams
in the cavity above and insert the plastic
dowels. Put the bracket in place and screw in
the 6x 40mm supplied screws, making sure
they are screwed all the way in and tight.
70 mm
30 mm30 mm
280 mm
30 mm
70 mm
375 mm
Open grill: Min distance 1200mm
Solid plate grill: Min distance 900mm
70 mm
123.5 mm
70 mm
30 mm
123.5 mm
85 mm
67
43 mm
Fig. 1
Page 5
FITTING THE FLUE COVER
3. Fix the lower telescopic section of the bracket to
the top of the rangehood by lining up the 8x fixed
threaded bolts with the 8x pre-drilled holes on the
lower bracket and fitting the 8x nuts and washers
and tightening up fully. (Fig. 3)
5. At this stage you will need to secure your 200mm
ducting to the outlet collar on the hood as it will
not be able to be done once the unit is hung in
place. (Fig. 5)
6. Slide the stainless steel flue cover (covers if
required) over the telescopic frame and lift the
whole hood into position. Depending on the height
of the ceiling the flue cover may need to be cut to
height. (Fig. 6)
200mm ducting
(not supplied)
4. Measure the required height to telescope the
bracket to its desired length and secure in place
using the supplied 10mm screws. (Fig. 4)
x 8
x 8
7. Lift the rangehood with the telescopic frame and
the 200mm ductwork attached and slide the
telescopic frame inside the top mounting bracket
until the spring loaded clips engage.
Fit the telescopic frame in place securely using the
supplied 10mm screws. (Fig. 7)
Fig. 3
Fig. 5
Bracket fixed
in ceiling
10mm screws
(supplied)
Screws
Screws
Screws
Screws
Fig. 4
Flue cover
Spring loaded
clips
Spring loaded
clips
10mm screws
Lift unit up
to bracket
Fig. 6Fig. 7
89
Page 6
EXTENDING THE FLUE COVER
8. Telescope the flue cover to the top, covering the
top bracket and secure in place using the 10mm
supplied screws. (Fig. 8)