Sirius SL906EML520SEM2XS316 User Manual

Congratulations on your purchase!

Thank you for choosing a Sirius product.

SL906 OFFBOARD series

UNDERMOUNT RANGEHOOD INSTALLATION INSTRUCTIONS

SL906EM-L 520 EAN #9351116000646
SL906EM-L 850 EAN #9351116000691
SL906EM-L 1000 EAN #9351116000769
SL906EM-L 1200 EAN #9351116000790

www.siriusbrand.com

1

CAUTION

BEFORE YOU INSTALL – please read

Sirius warranty covers only Sirius product. If you choose to install a non-Sirius branded accessory

such as flexible ducting, Sirius will only warrant the hood and motor. If installation is found to be the

cause of failure or issue then charges will apply for service and parts.

Flexible ducting is not permitted under any circumstances. Flexible ducting has been found to

increase noise levels, increase vibration and reduce airflow.

Sirius Semi-rigid or solid ducting can be used in lieu.

There is a range available to suit any application.

WARNING

The appliance must be installed and

connected to the power supply only by a

qualified technician.

• There shall be adequate ventilation of the room when the range hood is used at the same time as
appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the
room)

• The details concerning the method and frequency of cleaning

• There is a fire risk if cleaning is not carried out in accordance with the instructions;

• Do not flambé under the range hood;

• CAUTION: Accessible parts may become hot when used with cooking appliances.

Ducting available at www.siriusbrand.com

A reduction in the duct diameter from stated ducting size will void warranty.

If you are in doubt about the ducting, please contact Sirius on 1300 762 219 prior to installation

The symbol on the product or on its packaging indicates that this product
may not be treated as house-hold waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly,
you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed information about
recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased the
product. This appliance is marked according to the European directive
2002/96/EC on waste electrical and electronic equipment (WEEE).

2 3

WARNING

Min. 600mm - Max. 700mm for electric cooktops.
Min. 650mm - Max. 750mm gas cooktops.

If the rangehood is positioned above the max height
recommended, warranty may be compromised
as performance of the rangehood will be affected.
Measurement is taken from the top of the trivets to
the underside of the hood. (Fig.1)

600 - 700mm (electric)

650 - 750mm (gas)

SIDE VIEW FRONT VIEW

• The air being drawn can’t be conveyed through
or into a duct used to let out fumes from
appliances fed by energy other than electric
power (eg. centralized heating, radiators, water
heaters, etc.).

• Attention: remove any possible PVC film from the
stainless steel, including the filters.

• To externally vent, please comply with the
pertaining rules given by competent authorities.

• Provide the room with an adequate ventilation
when a rangehood and appliances fed by energy
other than electric power (gas, oil, or coal stoves,
etc.) are used simultaneously. The rangehood,
when evacuating the air, could generate a
negative pressure in the room which can’t exceed
the limit of 0.04 mbar, in order to avoid the
suck of exhausts deriving from the heat source.
Therefore the room should be provided with air
intakes to allow a constant flow of fresh air.

If the rating label in the rangehood shows the symbol
, the appliance is built in class II° and it does not
need any earth connection.
If the rating label in the rangehood does not show
the symbol , the appliance is built in class I° and it
needs the earth connection.

When performing the electrical connections on the
appliance, please make sure that the current-tap
is provided with earth connection and that voltage
values correspond to those indicated on the label
placed inside the appliance itself.

Before carrying out any cleaning or maintaining
operations, the appliance needs to be switched off.
If the appliance is not provided with a non-separable

600 - 700mm (electric)

650 - 750mm (gas)

(Fig. 1)

flexible cable and plug, or with another device
ensuring omnipolar disconnections from the grid,
with an opening distance between the contacts of at
least 3mm, then such disconnecting devices must be
supplied within the fixed installation.
If the fixed appliance is endowed with a supply cord
and a plug, the appliance has to be put in a place
where the plug can be reached easily.

The use of materials which can burst into flames
should be avoided in close proximity of the appliance.
When frying, please pay particular attention to fire
risk due to oil grease. Being highly flammable, fried
oil is especially dangerous. Do not use uncovered
electric grills. In order to avoid possible fire risk, all
instructions for grease-filter cleaning and for removing
eventual grease deposits should be strictly followed.

When ducting rangehood, options are as follows:

• NOTE: For SEM 1: From motor to exit point,
additional lengths of duct will be required from
the rangehood to the SEM 1 motor.

Roof vent - EASYROOF 150T/M

EASYROOF 200T/M

*Kit includes roof flashing

Download installation guide

Eave vent - EASYEAVE 150/200

Download installation guide

Wall vent - EASYWALL 150/200

Download installation guide

Ducting kits are not needed for SEM 2 motors as not
all components are required.

Individual Sirius Ducting components can be
purchased at www.siriusbrand.com.au or one of
our retail partners.

MOTOR INSTALLATION GUIDES

SEM 1, 2, 7, 8 MOTOR

Download installation guide

SEM 5 MOTOR

Download installation guide

NOTE

Rangehood and SEM motor cannot be installed

back-to-back. There must be a minimum of

2 metres between rangehood and motor for

noise reduction reasons.

WARNING: Failure to install the screws or fixing
device in accordance with these instructions
may result in electrical hazards.