Sioux Tools 1464, 1467, 1466, 1465 User Manual
SIOUX
Form
Dated
A221
1
1
I89
TOOLS
2901 FLOYD BOULEVARD Â SIOUX CITY. IOWA
INC.
INSTRUCTIONS
For
No's.
-
SIOUX 318" & 112"
1464; 1465, 1466, 1467
318"
COUPLER S NIPPLE
51
102
I
AIR
114" - 318"
DRILLS
BUSHING
I2
1
NIPPLE
AIR SUPPLY
The tool is designed to operate at approximately
A
7%
let.
commended. Pipe and fittings should
gives additional information. Note that hose fittings must have inlet holes
The tool is designed for use with filter and lubricator.
LUBRICATION
Fill the lubricator with Sioux No.
The gear case is filled with
hrs. of operation.
PLACING TOOL IN OPERATION
Drain water from the air compressor and blow condensation from the air lines before each
operation.
Place
and twice daily thereafter.
LOSS
Filter and inlet screen clogged.
Use of fittings with too small an inlet.
Use of an undersize hose.
Loss of air pressure.
Dirt in the tool.
Tool not lubricated.
Stuck governor.
Worn motor parts (vanes, end plates, cylinder) vanes worn to
be replaced.
h.p. compressor at
20
to
30
drops of Sioux No.
OF
POWER
100
1/2
oz.
lbs. per sq. in. with an air tank of
be
a
288
Air Motor Oil and set lubricator to
of Sioux No.
288
Air Motor Oil into the % inch inlet hose before using
90
pounds per square inch air pressure at the in-
minimum of
1207
Grease. Replace grease if necessary after
60
gal. or larger is re-
/a
inch diameter. The above illustration
9/32
inch or larger.
1-2
drops per minute.
13/32
inch in depth should
100
day's
PRINTED
IN
U.S.A.
This pdf incorporates the following model numbers:
DR1467
Loading...