Page 1
®
PROGRAMMING
Programming Instructions
Hz Key Chain Transmitters 2 and 4 channels
Hz Key Chain Trans
Read all instructions carefully before use.
1) Program the motor using a
standard transmitter as per the
quick reference guide
3) Touch the programming
contact on the back of the Key
Chain Transmitter with a metal
conductor (paper clip). The LED
on the front will start to flash
2) Press the programming button
on the standard transmitter until
the motor jogs up/down
4) Press the desired front button
while the LED is still flashing. The
motor will jog. This button will now
control the motor.
Paper
Clip
P
G
R
Programming
Contact
Flashing LED
Repeat steps 1 through 4 for other buttons to other motors if desired.
Note: Only program one motor per button. The 2 channel key chain can be used
to control 2 motors maximum and the 4 channel can control 4 motors maximum
Page 2
Programming Instructions
®
Hz Key Chain Transmitters 2 and 4 channels
Hz Key Chain Trans
Read all instructions carefully before use.
LOCKING/UNLOCKING TSA 4
A - Enabling the locking function - Once a locking code has been entered the TSA 4 will automatically lock the buttons after 2
minutes without a command to prevent unintended operation. The buttons can be unlocked as per section B.
1) Press the lock button
for 5 seconds
2) Enter a 4 key code
3) Validate the code by
pressing the lock button
4) Enter the same 4
key code again
5) Validate the code by
pressing the lock button
B - Unlocking the remote - After unlocking the remote, the buttons will remain active for 2 minutes before locking again.
1) Enter your 4 key
code
2) Validate the code by
pressing the lock button
3) The transmitter buttons are unlocked for normal use for 2 minutes.
After 2 minutes the transmitter will automatically lock the buttons again
C - Disable the automatic lock function
1) Press the lock button
for 5 seconds
2) After 5 seconds the locking
LED will go out. The locking
Function is now disabled.
REPLACING THE BATTERY
ATTENTION - The battery must be installed correctly with regards to the polarity. The battery must be installed with the + side facing away from the
transmitter board. Do not expose battery to high temperatures or water. Do not throw batteries in fire or water. Dispose of batteries correctly
Loading...