Simpson Electric Amik 100 Technical Specifications

Amik 100

Reference conditions for Accuracy

Reference temperature
Input waveform Sinusoidal (distortion factor 0.005)

Input frequency
Auxiliary supply voltage

Auxiliary supply frequency

23°C +/- 2°C

50 or 60 Hz ±2%
Rated Value ±1%

Rated Value ±1%

Accuracy

Voltage

Current

Frequency

±1% of range
(20... 100% of Nominal value)

±1% of range
(10... 100% of Nominal value)

0.5% of mid frequency

Input Voltage

Nominal input voltage
(AC RMS)

Max continuous input
voltage

Nominal input voltage
burden

System PT secondary
values

System PT primary
values

Phase –Neutral 290V L-N ,
Line-Line 500V L-L

120% of rated value
< 0.3 VA approx. per phase

(For external auxiliary meter)
100VLL to 500VLL programmable

on site.
100VLL to 692kVLL programmable

on site.

Overload Withstand

Voltage

Current

2 x rated value for 1 second,
repeated 10 times at 10 second
intervals

20x rated value for 1 second,
repeated 5 times at 5 min intervals

Operating Measuring Ranges

Voltage Range With
External Aux

Voltage Range With
Self Power

Current Range
Frequency

10… 120% of rated value

80… 120% of rated value
10 … 120% of rated value

45…65 Hz

0.025%/°C for Voltage

0.05%/°C for Current

Limit Switch (Relay)

Switching Voltage &
Current for Relay

Enclosure

Front
Front with seal (Option)
Back

IP 50
IP 65 **

IP 20

Input Current

Nominal input current
System CT secondary values

System CT primary values
Max continuous input

current
Nominal input current

burden

Auxiliary Supply

External Aux
Self powered **

Frequency range
VA burden

5A AC RMS
1A & 5A programmable on site
From 1A up to 9999A

(for 1 or 5 Amp )
120% of rated value

< 0.2 VA approx. per phase

40 V – 300V AC-DC (± 5 % )
Input voltage range from 80% to

100% of Rated value.
(Self powered meter is available
only in 3Phase 4 Wire and
Single Phase network.)
Auxiliary input is derived from
Phase 1 (R phase)

45 to 65 Hz
3 VA Approx.

Environmental

Operating temperature
Storage temperature

Relative humidity
Warm up time

Shock
Vibration

Safety

Pollution degree
Installation category
High Voltage Test

Applicable Standards

EMC
Safety

IP for water & dust

-20° to +70°C

-30°C to +80°C
0 to 95% non condensing

Minimum 3 minute
15g in 3 planes

10... 55 Hz, 0.15mm amplitude

2
III

3.3 kV AC, 50Hz for 1 minute
between Aux. and measuring
inputs

IEC 61326-1: 2005
IEC 61010-1-2001 ,
Permanently connected use

IEC60529