Page 1
WV
VW
Figure 3.
Insert bezel from the front and meter from the back of panel. Turn brackets to
engage slots in bezel. Insert screws into brackets and tighten assembly
against panel.
Complete Bezel Kit Cat. No. 01123
INSTRUCTION MANUAL
Bezel Mount for
Wide-Vue Models
1329, 1339, 1349, 1359, 1379
SIMPSON ELECTRIC COMPANY 520 Simpson Avenue
Lac du Flambeau, WI 54538-0099 (715) 588-3311 FAX (715) 588-3326
Printed in U.S.A. Part No. 05-11026 Edition 3, 05/07
Visit us on the web at: www.simpsonelectric.com
4
Page 2
About this Manual
WV
VW
To the best of our knowledge and at the time written, the information contained in this
document is technically correct and the procedures accurate and adequate to operate this instrument in compliance with its original advertised specifications.
Notes and Safety Information
This Operator’s Manual contains warning headings which alert the user to check for
hazardous conditions. These appear throughout this manual where applicable and
are defined below. To ensure the safety of operating performance of this instrument,
these instructions must be adhered to.
Warning, refer to accompanying documents.
!
Caution, risk of electric shock.
Drilling Template
1.890
4.812
.032
-.000
.032
-.000
2.750
+
2.406
3/16" - 1/4" dia. hole
for zero adjuster
access (optional)
Technical Assistance
SIMPSON ELECTRIC COMPANY offers assistance Monday through Friday
8:00 am to 4:30 pm Central Time. To receive assistance contact Technical Support or Customer Service at (715) 588-3311.
Internet: http://www.simpsonelectric.com
Warranty and Returns
SIMPSON ELECTRIC COMPANY warrants each instrument and other articles manufactured by it to be free from defects in material and workmanship under normal use
and service, its obligation under this warranty being limited to making good at its
factory or other article of equipment which shall within one (1) year after delivery of
such instrument or other article of equipment to the original purchaser be returned
intact to it, or to one of its authorized service centers, with transportation charges
prepaid, and which its examination shall disclose to its satisfaction to have been
thus defective; this warranty being expressly in lieu of all other warranties expressed
or implied and of all other obligations or liabilities on its part, and SIMPSON ELECTRIC COMPANY neither assumes nor authorizes any other persons to assume for
it any other liability in connection with the sales of its products.
This warranty shall not apply to any instrument or other article of equipment which
shall have been repaired or altered outside the SIMPSON ELECTRIC COMPANY
factory or authorized service centers, nor which has been subject to misuse, negligence or accident, incorrect wiring by others, or installation or use not in accord with
instructions furnished by the manufacturer.
This manual represents your meter as manufactured at the time of publication. It
assumes standard software. Special versions of software may be fitted, in which
case you will be provided with additional details.
The apparatus has been designed and tested in accordance with EN 61010-1, “Safety
Requirments for Electrical Equipment for Measurement, Control and Laboratory Use.”
This operationg guide contains information and warnings that must be followed by
the user to ensure safe operation and to maintain the apparatus in a safe condition.
Figure 1. Drilling Template
Cut panel as shown above. If access to the zero-adjuster is desired, locate as
indicated. Maximum panel thickness 1/4 inches.
Figure 2.
Position mounting brackets on upper two mounting studs with letters “WV” visible.
We reserve the right to make changes and improvements to the product without
obligation to incorporate these changes and improvements into units previously
shipped.
2
3
Loading...