Specifications and Main Features
- Skid Shoes Included in the Overall Length: 55”
- Height of Air Filter Housing: 14”
- Sweeper Bar in Mowing Position Fully Raised: 10”
- Sweeper Width the Tine True Width Auger: 52”
- Push Chute at the Base: 6’’
- Push Chute Maximum Angle of Rotation: 90"
- Tine Shaft Diameter: 20mm
- Elevation: 340 Pounds
Commands
- Spout Movement: Toggle switch on tractor console
- Spout: Electric drive from voltage: Toggle switch on tractor console
- Active Chipper Rotation: Turned on with the Faucet: Push to turn the With the knob: Pull to Switch on motor:
Pto Design
- Single stage: Type
- An externally mounted engine on a tractor’s front PTO. The power source is a tractor:
- Friction clutch: Electromagnetically controlled Shaft
- Jack vertical drive: Drive jack shaft
- Spline shaft as a horizontal rotary joint drive shaft coupled space without side flanges to bevel gear box:
- Cross shaft drive housing: Fore shaft: Forward shaft:
- Spline drive rotary bearing universal joint
- Roller driven chain with hardened sprockets in the final drive:
Building Arrangement
- Drive type: Electric Gearbox Reverse:
- Bearings with mounted screws passive sliding colonies:
- Mounted in front of bulgarians: Tractors with wide adjustable hardened skid shoes:
- Hitch and tractor frame bolted to the rear of the tractor:
- ‘ J’ type scrap bar made fully width high carbon steel:
- Traditional type steel tube or angle:
- Auger: Solid steel body
- Bearings sealed self aligning and ball:
Frequently Asked Questions
Q: What is the effective width of the snow thrower?
A: The effective width is 52 inches which is quite remarkable.
Q: How do you control the rotation of the spout?
A: Spout rotation can be operated by means of a toggle switch which is fitted on the tractor's dashboard.
Q: What type of drive is there on the snow thrower?
A: There is a single stage auger drive on the snow thrower that draws power from the tractor front pto.
Q: How heavy is the snow thrower?
A: The snow thrower weighs approximately 340 pounds.
Q: What adjustments can be made for different surfaces?
A: Skid shoes can be set for working on gravel or hard surfaces for level control of the snow thrower.
Q: What should I do if the auger does not rotate?
A: Inspect whether the front clutch switch of the tractor has been engaged or whether some foreign material is in the auger.
User Manual
Loading...