Simplicity S200X, S150X, TP 200-7224-E-AT-UV, IS1500Z, 5100075 User Manual

...

5100075

Rev. 2/2009

TP 200-7224-E-AT-UV

WARNING

Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).

Ferris & Simplicity Models

1. Park machine on a flat, level surface and engage the parking brake. Disengage the PTO switch, turn off the engine and remove the key from the ignition.

2. If the engine is hot, allow sufficient time for the muffler to cool to prevent a burn injury during installation.

3. Install the 3/8-16 x 2-1/2” bolts (B) through the hitch plate (A).

4. Install the hitch plate onto the bumper with the bolts in between the bottom and middle bumper tubes.

5. Install the back plate (C) and loosely secure with the 3/8-16 nylock flange nuts (D).

6. Center the hitch plate side-to-side on the bumper and tighten the hardware securely.

Installation Instructions

Trailer Hitch Kit

Part No. 5600031

Fits Ferris IS500Z, IS1500Z Series, & IS4500Z Series

Fits Snapper Pro S50X, S150X & S200X Series

Fits Simplicity Citation Series

Figure 1. Install Hitch Kit (Ferris & Simplicity) A. Hitch Plate B. 3/8-16 x 2-1/2” Bolts (4X) C. Back Plate D. 3/8-16 Nylock Flange Nut (4X)

Kit Contents:

Part No. Qty. Description

5401148 1 Hitch Plate Assembly 5400534A 1 Back Plate 5025013X20 4 3/8-16 x 2-1/2” Bolt 5025394 4 3/8-16 Nylock Flange Nut 5025013X10 4 3/8-16 x 1-1/4” Bolt

Figure 2. Installed Hitch Kit (Snapper Pro) A. Hitch Plate B. 3/8-16 x 1-1/4” Bolts (4X) C. Back Plate D. 3/8-16 Nylock Flange Nut (4X)

Snapper Pro Models

1. Park machine on a flat, level surface and engage the parking brake. Disengage the PTO switch, turn off the engine and remove the key from the ignition.

2. If the engine is hot, allow sufficient time for the muffler to cool to prevent a burn injury during installation.

3. Install the 3/8-16 x 1-1/4” bolts (B) through the hitch plate (A).

4. Install the hitch plate onto the bumper with the bolts in the middle two slots of the center column as shown in Figure 2.

5. Install the back plate (C) and loosely secure with the 3/8-16 nylock flange nuts (D).

6. Center the hitch plate side-to-side on the bumper and tighten the hardware securely.

Not for

Reproduction