Specifications and Main Features
- Model: 6500 Series Hydrostatic Tractor
- Engine Options:
- 12.5 HP (MFG. NO. 1691468, 1691624)
- 16 HP (MFG. NO. 1691263, 1691626)
- 17 HP (MFG. NO. 1691732)
- Mower Options:
- 42” Mower (MFG. NO. 1691423)
- 48” Mower (MFG. NO. 1691425, 1691736)
- Hydrostatic Drive System
- Speed Control:
- Forward: 0 - 5.5 mph
- Backward: 0 - 3 mph
- Ground Speed Control Lever
- PTO (Power Take Off) Lever
- Seat Safety Switch
- Attachments Lift Lever
- Clutch-Brake/ Parking Brake Pedal
- Mower Cutting Height Control Lever
- Mower Leveling Adjust Features
- Required Air Pressure:
- Front: 12 to 15 psi
- Rear: 6 to 8 psi
- Guidelines for Checking and Replacing the Battery
- Standard Maintenance Procedure
- Safety Interlock System
- Instructions on Operations, Maintenance Troubleshooting for the Operator’s Manual
Frequently Asked Questions
Q: What should I do if the engine does not start?
A: Please make sure that the ground speed control lever is in neutral position, that the PTO clutch lever is in OFF position and that the operator is seated in position and the fuel tank is not empty.
Q: What is the correct procedure for retaining the edges of the mower blades?
A: Take off the mower and then with the help of a file sharpen the blades, ensuring to check it for balance with a balancing machine.
Q: Is there a limit to the slope ratio that I can mow?
A: A slope angle greater than 16.7 degrees or ratio greater than 3:1 is not suited for mowing.
Q: After what duration should I oil change?
A: So long as the machine is used for 100 operating hours, the engine oil should be changed every 5 hours of working for the first time.
Q: How does one set the height of the mower?
A: Locate the cutting height control lever and use it to set the height you desire.
Q: Which type of fuel is to be used?
A: The owner's manual specifies the fuel to be regular unleaded gas, therefore use that.
Q: How can the problem of an uneven mower cut be resolved?
A: In most cases uneven cuts occur due to improper leveling of the mower and uneven pressure in the tractor tires, steps can be taken to fix these issues and an even cut can be achieved.
Q: How should fuel be filled to eliminate any risks?
A: Avoid filling petrol when the machine is in an already running state or hot as this can be dangerous, still ensure to clean the area that surrounds the fuel cap to avoid any mess when opening it.
Q: How frequent is lubricant application needed for the tractor and lawn mower?
A: Lubrication of tractor and mower implements can be done as per the usual care regimen, however, it is necessary to contract the integration process in hot or dusty environments.
User Manual
Loading...