Specifications and Main Features
- Engine Manufacturer: Briggs and Stratton, single cylinder four cycle, naturally aspirated.
- Horsepower: 8 hp at 3600 rpm and 10 hp at the same 3600 rpm.
- Engine Type:
- 8 HP:190707 or 193707. (Accepted I/C).
- 10 HP: 220707 or 255707 for Standard use and 256707 for I/C use.
- Crankshaft: Vertical unbalanced crankshaft used for two models of, 190707 and 220707. The other models use a neutral balanced vertical crankshaft.
- Engine Displacement: 8 hp- 19.44 in cube or 3185 cc 10 hp - 22.04 cube inch or 3612 cc.
- Bore and Stroke:
8HP: 3 x 2.75”
10 HP: 3.44 x 2.38”
- Ignition System: Magneto high tension.
- Mechanical Governor: Flyweight and Engine Type 1:870.
- Choke: Speed control lever.
- Start System: 12 gear volt motor.
- Alternator: 3 amp D.C. current.
- Air Cleaning System: Oil foam reusable for cleaning.
- Maximum Fuel Quantity per Engine: 7 quarts.
- Spinning Block Maximum Holding Capacity:
8 HP - 2.25 pints; 10 HP - 3 pints.
- Transmission Gear Speed @ 3400rpm
First gear ratio: 1.3 miles per hour
Second gear ratio: 2.0 miles per hour
Third gear ratio: 3.1 miles per hour
Fourth gear ratio: 3.8 miles per hour
Fifth gear ratio: 4.5mph miles per hour
Reverse gear: 1.5 mph.
- Type of Braking: band type 7 inch braking types on rear axles.
- Using Tires Pressure: 4.10/3.50-4.
- Rear Tires: 16 x 6.50-8 Pneumatic
- Type of Spark Plug: Champion Autolite Robert
- Short plug: CJ-8, Long Plug: J-8
- Resistor short plug: RCJ-8, Resistor long plug: RJ-8
- Spark Plug Gap: 0.030" (.76 mm)
- Ignition Point Gap: .020" (.51 mm)
- Specifications are subject to change without notice.
Frequently Asked Questions
Q: What kind of engine this device has?
A: The engine is a Briggs & Stratton single cylinder, 4-cycle air cooled type.
Q: What is the device’s horsepower?
A: The device comes in two variants that is 8 HP and 10 HP.
Q: State the fuel capacity?
A: The fuel capacity can contain up to 7 quarts.
Q: What are the adjusting directions for the mower height?
A: To raise or lower the mower, use the mower height control lever.
Q: What if the engine does not start?
A: Make sure the gear shift lever is positioned at the neutral position and that the PTO clutch lever is completely off.
Q: How frequent is oil level check expected?
A: Oil level checks should be conducted on a regular basis, and oil changing should be done at manufacturer specified intervals.
Q: Can children use the device?
A: No, this machine should not be used alone by children.
Q: In what way should the mower blades be maintained?
A: Blades need to be sharpened and balanced on a regular basis. Maintenance always starts with ensuring that the parking brake is set and the engine turned off.
Q: Is general maintenance to be performed, and what does it entail?
A: Ensuring correct fluid levels and lubricating the necessary components on a regular basis can be termed as basic maintenance, as well as checking for any excessive wear.
User Manual
Loading...