Page 1
Installation
Instructions
Oval Headlight Kit
Part No. 1687237
INSTALLATION
1. Models with tube handle bars: Mount the headlight to
the handle bars using the clamp provided.
Models with channel handle bars: Mount the headlight assembly directly to the handle bars using an
available hole in the channel assembly.
2. Check that the light does not interfere with the operation of the controls, or control linkage. If it does, relocate it.
3. Route the wire leads to the engine.
4. Connect the bullet lead to the engine’s stator coil output.
5. Connect the eyelet connector to the foot of the
engine block, secure to one of the engine mounting
bolts.
6. Secure the wires, using the wire ties provided, to the
handle bars away from moving parts. Be sure all
controls function correctly.
For Fits Intermediate, Pro, and Large Frame Snowthrowers
Figure 1. Contents
Kit Contents:
Ref Part No. Qty. Description
1 1732322 1 Headlight Assembly
2 2825094 2 Wire Ties
3 1733415 1 Bracket, Clamp
This kit adds an optional headlight to
snowthrowers equipped with an stator coil.
Before beginning any service work turn off the
engine, remove the key, and wait for all
movement to stop. Wait for hot surfaces like the
muffler and cylinder head to cool.
WARNING
Form No. 1733417-00
Rev. 7/2006
© 2006 Simplicity Manufacturing, Inc. All Rights Reserved
TP 200-4352-00-AT-SN
MANUFACTURING, INC.
500 N Spring Street / PO Box 997
Port Washington, WI 53074-0997 USA
Loading...