900-Lumen LED Projector Manual
Page 3 of 14
SAFETY WARNINGS AND CAUTIONS
WARNING: To reduce the risk of re or shock hazard, do not expose this product to rain or
moisture.
CAUTION: To reduce the risk of electric shock, do not remove cover or back. No userserviceable parts inside. Refer servicing to qualied personnel.
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for your projector. Before
using your projector, read all instructions and cautionary markings on the product.
DANGER: To reduce the risk of re or electric shock, follow these instructions.
FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation. Your adapter is ETL listed to UL standards and meets all applicable FCC standards.
WARNING: Changes or modications to this unit may cause interference and void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful inteference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1. Re-orient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Consult Sima Customer Service at www.simaproducts.com if the problem still exists.
!