SilverStone SST-RMS01 operation manual

Quick Installation Guide of RMS01

CHASSIS

FRONT BRACKET

MIN=A+38 (22" Below = 632mm)

EXT=300MM

REAR BRACKET

Align the spring clip on chassis (inner) member of the pre-formed bayonets on both sides of the chassis. Push back the inner member to allow the rail slide to be fixed to the rackmount chassis. Moreover, please make sure the spring clip installation has been completed on the rackmount chassis when finishing this step.

*Bayonet on chassis shall be pre-formed as per the recommended dimension and location. * If there is concern for rackmount security, we have provided screws to allow further reinforcement of the fixed rackmount chassis. *If you need to remove the inner member from the rackmount chassis, please pull up spring clip first and then push forward to allow the spring clip to separate from the inner member. If you had already installed the screw in your rackmount chassis, please remove the screws first.

G11223550