ADAPTER SERIES
SST-AD60-C
Compact, intelligent multi-voltage 60W USB Type-C adapter
▓ Maximum 60W 3A fast charging for USB Type-C equipped laptops, tablets, and mobile phones
▓ Intelligent detection and auto adjust to various DC voltage output of 20V / 15V / 12V / 9V / 5V
▓ 25mm thick compact and slim design for easy transport
▓ Up to 88% high efficiency
▓ Meets DoE level 6 standard for energy efficiency
▓ Multiple protection circuitry and safety certification
SPECIFICATION
Adapter Series
AD60-C
60W USB Type-C AC-DC Adapter
1. Input Characteristics:
ITEM CONDITION SPECIFICATION
1.1 Rated Input Voltage: 100Vac~240Vac
1.2 Input Voltage Range: 90Vac to 264Vac
1.3 Input Frequency Range:
1.4 Input Current:
1.5 Efficiency: (Warm up 10minutes later)
1.6 Power Saving: 115Vac, 230Vac / 5Vdc_0A load 0.1W
1.7 Inrush Current:
1.8 DOE(Level VI):
47Hz to 63Hz ( ± 1Hz )
100Vac, 240Vac / 3A load 2A
5Vdc / 3A load
9Vdc / 3A load
12Vdc / 3A load
15Vdc / 3A load
20Vdc / 3A load
100Vac, 240Vac / 3A load
(1)115Vac / 0A load
(2)115Vac / 25%,50%,75%,100% load
(Averag e Activ e Mode
Efficiency ,Warm up 30 minutes later)
79%
84%
85%
85%
86%
( DC Cable≦800 mm,18AWG)
Shall be less than the rating of adapter
critical component (including rectifiers, fuse
surge and current limiting device)
5Vdc≦0.1W
5Vdc≧81.39%,
9Vdc≧86.62%,
12Vdc≧87.4%,
15Vdc≧87.73%,
20Vdc≧88%
( DC Cable≦800 mm,18AWG)
01
2. Output Characteristics:
ITEM CONDITION SPECIFICATION
2.1 Output Rated Voltage:
2.2 Output Current: at constant voltage mode
2.3 Output Voltage Setting: at the output end of DC cable
2.4 Output Voltage Ripple and Noise:
(0.1uF Ceramic Cap. and 35V 47uF
Aluminum Cap. Paralleled between
the end of output cable)
2.5 Turn-On Delay Time: At 100Vac / 3A load, output voltage
2.6 Hold Up Time: At 100Vac or 240Vac / 3A load,
2.7 Rise Time: At 100Vac / 3A load, DC output rise
2.8Fall Time At 100Vac / 3A load, DC output fall
2.9 Dynamic Load Change: （1） Output load step is：
3.0 Overshoot: 100Vac, 240Vac / 0A and 3A load 5V ± 10%
100Vac, 240Vac / 0A~3A load 200mVp-p
shall remain regulation
output voltage shall remain regulation
time from
5V to 9V
5V to 12V
5V to 15V
5V to 20V
time from
9V to 5V
12V to 5V
15V to 5V
20V to 5V
【1】0 % ~50 %
【2】50 %~100 %
（2） S/R=0.5A/us
（3） Frequency is 100Hz and 1 KHz
5V/9V/12V/15V/20V
5V/3A
9V/3A
12V/3A
15V/3A
20V/3A
5V±5%
9V±5%
12V±5%
15V±5%
20V±5%
DC CABLE
≦800
(
3Sec
5ms
275ms
275ms
5V ± 15%
9V ± 15%
12V ± 15%
15V ± 15%
20V ± 15%
MM
,18AWG)
02
3. Protection Characteristics:
ITEM CONDITION SPECIFICATION
3.1 Short Circuit Protection:
3.2 Over Voltage Protection:
3.3 Over Power P rotection:
3.4 Over Temperature Protection:
3.5 Over Current Protection:
When an internal fault occurs, or an external fault
is applied to the power supply, such that an
overload or short circuit is applied to the output,
the power supply shall shut down and enter
auto-recovery mode.
The adapter will enter into shut down that means
no output while over voltage happened at output
terminal that caused by internal fault, the outp ut
trip voltage shall not exceed 27 volts. That will be
return to normal state by AC reset.
When an internal fault occurs, or an external fault
is applied to the power supply, such that an
overload or short circuit is applied to the output,
the power supply shall shut down and enter
auto-recovery mode.
The power supply will enter into shut down while
the abnormal thermal rise occurs. That will be
return to normal state by AC reset.
115Vac, 230Vac / Full load
Shutdown and no damage
Shutdown and no damage
Shutdown and no damage
No fire, no smoke
Output current limit :
4A(MAX) for 5Vdc / 9Vdc
12Vdc / 15Vdc / 20Vdc
03
4. Environmental Characteristics:
ITEM CONDITION SPECIFICATION
4.1 Electric Fast Transients:
Refer to IEC61000-4-4
4.2 Lightning Surge:
Refer to IEC61000-4-5
4.3 Electron Static Discharge:
(Refer to IEC61000-4-2 Energy Storage
Capacitor 150pF; Discharge Resistor
330)
Impulse: 1kV applied to L,N
1kV applied differential mode
2kV applied common mode
Air Discharge: 8 KV
Contact Discharge: 4 KV
Normal operation shall be continued
Normal operation shall be continued
Normal operation shall be continued
Normal operation shall be continued
4.4 Cooling:
4.5 EMI: Adapter compl y with the following
national standards:
EMI Conducted Emission
EMI Radiated Emission
4.6 Safety conforming:
4.6.1 Department of Energy【DOE】
4.7 LEAKAGE CURRENT:
4.8 Dielectric Strength: (Hi-Pot)
4.9 Temperature:
4.10 Humidity: Operating
Natural air cooling
1.Full Load
2. The power supply with internal filter can
Regulated by customer
264Vac / 50Hz
Between AC input and secondary applied
AC 1.5KV / test time 1 minute / cut off
current shall be less than 10mA
Operating
Storage
Storage
04
meet.
FCC PART 15J CLASS B
CISPR22 EN55022 CLASS B
VCCI LEVEL Π
Comply with DOE standard
0.25mA
0 to 40C
-20 to +80C
20% ~ 80%
10% ~ 90%
5. Mechanical Characteristics:
ITEM CONDITION SPECIFICATION
5.1 Dimension (Length x Width x Height): 92 X 77.3 X 25.4 mm
5.2 Adapter weight:
5.3 Input AC socket Type:
5.4 Vibration Test:
5.5 Acoustic Noise:
230g (typical)
IEC 320-C14 Type
（1）Non-operating, 0.01g
slopping to 0.02g
And maintain 0.02g
（2）PSD=3.13grms, 15 minutes/axis
Vibration duration:15minutes
（3）
Vibration waveform:Random
（4）
Force Direction X,Y,Z
（5）
（1）Position the microphone 30
centimeters above the x-y center of
the AC adapter
（2）Input voltage:110Vac/60Hz
2
/Hz at 5Hz
2
/Hz at 20Hz,
2
/Hz from 20Hz ~ 500Hz
220Vac/50Hz
Normal operation shall be continued.
The EUT < 30dB
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,and
(2) this device must accept any interference receivcd,
including interference that may cause undesired
operation.
05
NO. G11232611
Loading...