SilverStone LC02 User Manual

Disassemble Chart

HDD TRAY

STANDARD ATX MB

220W PSU WITH PFC

IEEE 1394+USB+MIC+SPK

SLOT*2

FRONT PANEL

POWER SW

TOP COVER

SLIM

3.5 BAY

Product Overview

SST-LC02

Specification:

Drive Bay: Slim optical drive x 1, 3.5" x 1 ( Hidden )
Slot : 2
M/B Type: Standard ATX and Micro ATX
Color: Silver & Black
Power Supply: Flex 220w Single with PFC
USB Port: USB x 2, IEEE1394 x 1, Audio x 1, MIC x 1
Add on card: PCI-E* or PCI riser card *(RC02 PCI-E riser card is sold separately)*
Weight: 2.5 kg
Dimension: 295 mm ( D ) x 382 mm ( W ) x 100mm ( H )
Cooling System: Right - 60mm fan x 1, left - 60mm fan slot x 1

optical drive

PCI-E* or PCI riser card

*(RC02 PCI-E riser card is sold separately)*

NO:G11400246

June

, 2006

This is a unique product, please read the following detailed
installation guide we have prepared meticulously for you.

We separate the assembly to three steps as below:

Please unscrew the 2 screws from the
back panel,slide the cover backward
slowly and lift it up to remove.

Please take out the tray for hard drive
and slim optical drive.

Please take out the slim optical drive
adapter and tighten up at the Slim
optical drive

Please place the slim optical drive
into its position on the tray parallel.

And tighten up with two M2*3 screws on
left side holes first.

Please place the hard drive into its position
on the tray parallel,and take tighten up with
2pcs #6-32*6 screw on left side holes and
2pcs on the back side holes .

Move over all wires.

Please put the insulation spacer on all
stand off.

Plug in the PCI riser card to the slot of
motherboard.

Plug in the RC02* riser card into the
PCI-E slot on the motherboard.
*(RC02 PCI-E riser card is sold
separately)*

Tighten up the riser card with slot bracket
on the back panel of the case.

To install the motherboard, make sure the
holes position are right above the stand off,
tighten up with M3*6 screws gently through .
the holes into the stand-off.

Plug in the PCI card into the slot of PCI riser card.

Put the tray for hard drive and slim
optical drive on left upper side of case,
and connect the flat cable and power wire
for hard drive first.

Please connect the power wire for Slim
optical drive.

Please connect the flat cable for slim
optical drive.

Please tighten up the tray for hard drive
and slim optical drive.

After all installation is finished, please
put top cover back gently on the case frame,
then slide it forward slowly until touching
the front panel, and fasten 2 screws at the
back panel.

And one on the bottom of right side.

Please tighten up with 2pcs #6-32*6
screw on the bear holes.