SilverNet LITE 95, LITE 240, MAX 95, MICRO 240, MAX 240 Installation Manual

MICRO 95/240 LITE 95/240/500

MAX 95/240/500/1000 BASE 500/ACCESS 1200

BASE 500 90/AP 1200 90 BASE 500 360/AP 1200 360

Pro Range

Installation Guide

Version 1 (31/05/2017)

Radio frequency Interference

Requirements

The operation of this device in the 5.15 GHz to 5.25 GHz frequency range is
restricted to indoor use. FCC regulations require this product to be used
indoors while operating at 5.15 GHz to 5.25 GHz to reduce the potential for
harmful interference. However, the operation of this device in the 5.25 GHz
to 5.35 GHz frequency range is allowed for both indoor and outdoor use.
High power radars are allocated as primary users of the 5.25 GHz to 5.35
GHz and 5.65 GHz to 5.85 GHz bands. These radar stations can cause
interference with and/or damage to this device.

FCC Warning

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. No
guarantee exists that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception (determined by turning the equipment off and on), the user is
encouraged to try to correct the interference by one or more of the following
measures:

• Reorient or relocate the radio/TV receiving antenna.

• Increase the separation between the equipment and the radio/TV

receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the radio/TV receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Modifications made to the product, unless expressly approved by
SilverNet Limited, could void the user’s authority to operate the
equipment.

RF Exposure Requirements

To ensure compliance with FCC RF exposure requirements, the antenna used
for this device must be installed to provide a separation distance of at least
30 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or radio transmitter. Installers and
end-users must follow the installation instructions provided in this user
guide.

CE Statement

The PRO RANGE system is intended to be used by suitably trained
individuals or organisations who are familiar with the requirements of the
R&TTE directive. In particular the client must ensure that appropriate
antennas and transmit power levels are selected to ensure that all power
limits are met. Hereby, SilverNet Limited declares that this device is in
compliance with the essential requirements and other relevant provisions of
the R&TTE Directive 1999/5/EC. However, the use of the following warning
symbol

Means that this equipment is subject to restrictions of use in certain
countries and selection of the correct country of operation (country code)
will ensure that the device operates only on the frequencies permissible

within that country. It is also the operator’s responsibility to ensure that

appropriate licenses have been sought when operating on licensed
frequencies, for example UK Band C, 5725-5850 MHz

Copyright Information

Copyright ©2017 all rights reserved. No part of this publication may be
reproduced, adapted, stored in a retrieval system, translated into any
language, or transmitted in any form or by any means without the written
permission of the supplier

Contents

Radio frequency Interference Requirements ..................................... 2

FCC Warning ......................................................................................................................... 2

RF Exposure Requirements ............................................................................................. 3

CE Statement ....................................................................................................................... 3

Copyright Information ...................................................................................................... 3

Declaration of Conformity .............................................................................. 5

Introduction ........................................................................................................... 6

Features and Benefits ....................................................................................................... 7

Installation ............................................................................................................. 8

Package list ........................................................................................................................... 8

Prepare the radio unit to mount to a pole ................................................................ 9

Device Panel Views and Descriptions ................................................... 11

Antenna Alignment .......................................................................................................... 12

Installation Direction ....................................................................................................... 13

Mount the Unit on a Pole ............................................................................................... 13

Declaration of Conformity

SilverNet Limited declares the following:

Product Name: PRO RANGE

Model No: MICRO 95/LITE 95/MAX 95/MICRO 240/LITE 240/MAX 240/LITE

500/MAX 500/BASE 500/MAX 1000/AP 1200 conforms to the following Product

Standards:

This device complies with the Electromagnetic Compatibility Directive (89/336/EEC)

issued by the Commission of the European Community. Compliance with this

directive implies conformity to the following European Norms (in brackets are the

equivalent international standards.)

Electromagnetic Interference (Conduction and Radiation): EN 55022 (CISPR

22)

Electromagnetic Immunity: EN 55024 (IEC61000-4-2, 3, 4, 5, 6, 8, 11)

Low Voltage Directive: EN 60 950: 1992+A1: 1993+A2: 1993+A3: 1995+A4:

1996+A11: 1997.

Therefore, this product is in conformity with the following regional

standards: FCC Class B: following the provisions of FCC Part 15 directive, CE

Mark: following the provisions of the EC directive.

SilverNet Limited also declares that:

The wireless card in this product complies with the R&TTE Directive (1999/5/EC)

issued by the Commission of the European Community. Compliance with this

directive implies conformity to the following:

EMC Standards: FCC: 47 CFR Part 15, Subpart B, 47 CFR Part 15, Subpart C

(Section 15.247); CE: EN 300 328-2, EN 300 826 (EN 301 489-17)

Therefore, this product is in conformity with the following regional

standards: FCC Class B: following the provisions of FCC Part 15 directive, CE

Mark: following the provisions of the EC directive.