96LED Solar Security & Flood Light
Operation & Installation Instructions
1. PARTS CONTAINED
1) Solar panel box (1pc)
2) Double flood light with sensor (1pc)
3) Twin wire connected to flood light (1pc)
4) Screw and wall plug (1pc)
2. INSTALLATION
The light can be installed in following steps:
2.1 Installation of solar panel box
1) Choose a place where sunlight is abundant during daytime
The solar panel box MUST be installed in a location where it can receive maximum sunlight during
daytime hours. Any cover that shades the panel will affect its ability absorb sunlight and decrease the
amount of power and duration of the flood light. The selected location should not be near a night time
light source such as porch lights, street lights, etc.
2) Installation of wall mounting bracket
Fix the wall mounting unit to an appropriate surface by using provided screws and drywall anchors, and
then cover the screws by provided black caps.
2.2 Installation of flood light
1) Choose a place you need to illuminate at night.
2) Mount the light by using provided screws.
3) Readjust the angle of the motion sensor by using the joint.
4) Readjust the angle of light head as needed.
5) Loosen the wire and insert the plug into the jack positioned at the bottom of the solar panel box
2.3 Loose the wire and insert the plug into the jack positioned at the bottom of the solar panel box.
2.4 After installation finished, turn ON the switch positioned at the bottom of solar panel box.
Your installation is now complete. Your security light will function automatically from now on.
Innovative Solar Solutions | 2917 State Hwy 7, Bainbridge, N.Y. 13733 | Ph: 800.786.0329 | www.SiliconSolar.com
3. OPERATION
There are three dials located on the PIR section of the light these are used to adjust sensitivity (DISTANCE),
lighting time (TIME) and darkness levels (LUX) .These are all adjustable with the PIR dials
1) Sensitivity (distance)
Distance the light can be activated by motion is
approx 3 to 10 meters.
2) Lighting time (time)
Preset lighting time is 1~4 minutes.
3) Darkness (lux)
The ambient luminance when the light can be
activated by motion.
a. Twist to the maximum, lamp will be only
activated in dark. (Factory preset)
b. If you want it working in environment of little light, please adjust the “LUX” button or twist it the
minimum if you want it working in environment of strong light (daytime).
4. TROUBLESHOOTING INFORMATION
The performance of solar powered motion-sensor light depends upon the amount of sunlight available during
daylight hours to charge the batteries to enable nighttime operation. If it is not functioning properly, use the list
below to find and correct the problem.
1) Make sure the solar panel box is located in an area where the solar panel gets the maximum amount of
sunlight every day.
2) If the weather has been rainy or overcast for a period of long time, the battery will not be charged for
operation at night. This is normal.
3) Dirt build-up on the solar panel will not allow the battery to fully charge. This will cause the light to
malfunction.
a. Clean it regularly with a dampened cloth or paper towel. Don’t use strong detergents or acid
based cleaners.
4) If everything above doesn’t make your light work, the battery needs replacement.
Innovative Solar Solutions | 2917 State Hwy 7, Bainbridge, N.Y. 13733 | Ph: 800.786.0329 | www.SiliconSolar.com
5. BATTERY CHANGING
Do not open the unit unless your warranty has already expired
If your lights should begin to illuminate dimly or for shorter duration of time, you should replace the
rechargeable battery in the following way:
Change battery in following steps
1) Unscrew 4 screws and remove bottom from the battery box.
2) Disconnect two terminals from battery and take out old battery.
3) Replace new battery with the same specifications as old and remount in reverse steps as above.
Warning:
1) Do it carefully to prevent wires from being damaged.
2) Be sure that battery polarities are correct. Wrong polarity is dangerous.
3) Do not dispose of old battery. It should be recycled.
Innovative Solar Solutions | 2917 State Hwy 7, Bainbridge, N.Y. 13733 | Ph: 800.786.0329 | www.SiliconSolar.com
Loading...