
Signature Series 418 Mhz
VIBRA-CALL 3
™
RECEIVER
INSTALLATION AND OPERATIONS MANUAL
VC4003-SS Page 1

Installation and Operations manual
Signature Series 418 Mhz VIBRA-CALL 3 Receiver and Docking Port
Model # VC4003-SS
General
The Vibra-Call 3 is a body worn battery operated alerting device that includes the Vibra-Call 3 Docking Port equipped
with battery backup. It can be used with any Silent Call Signature Series 418 MHz transmitter. The transmitters
available are the Sound Monitor, Telephone, Doorbell, Smoke Detector, CO Detector, Fire Alarm Transmitter,
Door/Window Access, Weather, and Pressure Sensitive Door or Bed Mat.
Installation
Installing the Vibra-Call 3 receiver and Docking Port consists of locating it where it can be seen most effectively for
the user. If using the Bed Vibrator or optional Strobe Light then place the Docking Port on a table or night stand
near your bed.
Plug the power supply into the DC barrel type female jack on the back of the Docking port (See locations
below) and then into any standard household 120v AC outlet.
Turn the power switch to the on position. This will also turn on the backup battery.
If using the Bed Vibrator or optional Strobe Light, then plug those into the corresponding locations on the
back of the Docking Port.
Charging
You will need to charge your Vibra-Call 3 receiver for 8 hours prior to the first use.
Pull the arrow tab from battery door.
Place the Vibra-Call 3 receiver into the Docking port.
angle to install properly into the Docking Port. If you do not do this you risk damaging the charging
pins.
o
If using the Leather Pouch you must remove it before placing the receiver into the Docking Port.
o
If using the optional Rubber Skin you can leave that on the receiver when placing into the
Docking Port.
The Vibra-Call 3 Receiver will vibrate to let you know that it has been placed into the Docking port
properly.
Note* You must lean the receiver back on a slight
VC4003-SS Page 2