SIL 107 Series, 107-12A User Manual

MULTIPLIER

Type 107-12A

User Guide

Doc ref ud107-12a.vp Rev 3

WARNING!

It is important that this guide is read and fully understood before
attempting installation or commissioning of the instrument.
Instructions appearing in this document, and current safety
legislation, must be observed to ensure personal safety and to
prevent damage to the instrument or equipment connected to it.

The instrument should be installed, commissioned and operated
only by suitably qualified and authorised personnel.

Safety and EMC information

Safety: EN61010 -1
Immunity: EN50082-1
Emissions: EN50081-1
CE certified

The specifications for the instrument must not be exceeded. If
the instrument is used in a manner not specified, the
protection provided by the instrument may be compromised.

The instrument must be installed in an enclosure that provides
adequate protection against electric shock.

Ensure that power to the instrument is switched off and signal
wiring isolated from hazardous voltages before carrying out
installation or maintenance.

The instrument is designed for installation in a clean, dry
environment (Pollution degree 1).

Stroud Instruments Ltd strongly recommends that repairs and
re-calibration work are done on a return to factory basis in
order that our quality standards, product specifications and
safety precautions are not compromised.

The instrument is double insulated

Note: Clean with a moist cloth - USE NO SOLVENTS.

Page 1

Installation

WARNING: Installation should be
conducted by appropriately skilled and
authorised personnel only.

WARNING: Ensure that power to the
instrument is switched off and signal
wiring isolated from hazardous voltages
before carrying out installation.

WARNING: The instrument must be
installed in an enclosure that provides
adequate protection against electric shock.

Location

¨ The instrument is designed for

installation in a clean, dry environment

¨ Do not install near to switch gear,

motor controllers or other sources of
strong magnetic fields.

¨ Avoid exposure to direct sunlight and

ensure the ambient temperature inside
the enclosure that the unit is mounted
in will not exceed our specification.

Plug in Module
Retaining Screws

Optional DIN Clip

Dimensions in mm

Module height 95mm, units with dial 117mm

Fixing

107 Series Modules are designed to be
fitted to any flat dry surface using two
4mm screws. Alternatively, by fitting an
optional DIN clip, they may be clipped to
a rail conforming to BS5584:1978,
EN50 022, DIN46277-3.
Grommets are provided on three sides of
the base section and there are two rear
entry knock outs in the bottom.

Page 2