SIIG US2253 Quick Installation Manual
1
USB 2.0 8-in-1 Reader/Writer
Quick Installation Guide
Features and Benefits
• Compliant with high-speed USB 2.0
specifications
• Compliant with USB Storage Class 1.0
specifications
• Low power consumption-powered from
the system. No power adapter required!
• Hot-swapping feature allows you to
attach/detach USB devices without
powering your computer off
• Designed for devices using CF type I/II,
IBM Microdrive, SM, Memory Stick (Pro),
MagicGate Memory Stick, SD and MMC
memory cards
Note: USB 2.0 devices are limited to USB
1.1 speed when they are connected to
USB 1.1 host adapter or USB 1.1 hubs.
04-0299D
2
Memory Stick
MagicGate MS
Memory Stick Pro
USB Connector
Layout
Figure 1. Layout
Important: When the reader/writer is
connected to the computer the Power/Activity
LED will be on.
Note: Do not unplug the reader/writer
or remove your memory card(s) while
the Power/Activity LED is flashing.
Smart Media
CF/Microdrive
SD/MMC
Power/Activity LED
3
System Requirements
• PC or Mac computer with an available
USB port (USB 2.0 recommended)
• Windows 98SE/ME/2000/XP
• Windows Server 2003
• Mac OS X (v10.1.3) or later
Package Contents
• (1) USB 2.0 8-in-1 Reader/Writer
• (1) USB cable (Type A to Mini 5-pin)
• (1) Driver CD
• This Quick Installation Guide
Installation
Windows 98SE
Do not connect the reader/writer until after
the driver has been installed.
1. Boot up your system and insert the driver
CD.
4
2. Autorun should start the installation. If
Autorun does not start, click Start, then
Run. Type D:\Autorun.exe, then click
OK. (Change D: to match your CD-ROM
drive letter)
3. Click Install Device, follow on-screen
instructions to install the driver, then
restart Windows.
4. Connect the reader/writer to a USB port
and the drivers will load automatically.
Windows 2000
Windows 2000 with service pack 2 or earlier:
Do not connect the reader/writer until after
the driver has been installed.
1. Boot up your system and insert the driver
CD.
2. Autorun should start the installation. If
Autorun does not start, click Start, then
Run. Type D:\Autorun.exe, then click
OK. (Change D: to match your CD-ROM
drive letter)
Loading...