SIIG 1x4 3G-SDI Splitter, JU-MR0412-S1 Quick Installation Manual

1

04-0732A

Introduction

The 1x4 3G-SDI Splitter allows you to broadcast
3G-SDI signals from one source to four outputs.

Key Features and Benefits

• Replicates and distributes content from 1
3G-SDI source to 4 outputs

• Operates at 270Mb/s, 1.485Gb/s and

2.97Gb/s data rates

• Supports HD formats:

• 720p24, 25, 30, 50 & 60

• 1080i50 & 60

• 1080p24, 25, 30, 50 & 60

• Supports 525i & 625i SD formats

• Metal housing and wall-mountable

Package Contents

• 1x4 3G-SDI Splitter

• Power adapter

• Quick installation guide

1x4 3G-SDI Splitter

Quick Installation Guide

2

Layout

Figure 1: Layout

Hardware Installation

1. Power off all devices you plan to connect to
this splitter.

2. Connect your SDI source to the splitter’s
SDI IN connector using a SDI cable (not
included).

3. Connect your displays to the splitter’s SDI
OUT connectors using a SDI cables (not
included).

4. Connect the splitter's power adapter.

5. Turn on the displays, then the SDI source.

6. The 1x4 3G-SDI Splitter is now ready to use.

Power jack adapterSDI IN

SDI OUT

LED indicators

USB port

(for future firmware

upgrade)

3

Dip Switch

• Re-Clock: Receives a signal and retransmits
it at a higher level and /or higher power, or
onto the other side of an obstruction, so the
signal can cover longer distances

• LB SEL0: Disabled (Not used)

• LB SEL1: Disabled (Not used)

Note: Pin up: Enabled (on)

Pin down: Disabled (off)

Figure 2: Dip Switch

LB SEL1

(Not used)

Re-Clock

LB SEL0

(Not used)