SIIG 1x8 HDMI Splitter with 4Kx2K & EDID Management Installation Manual

1x8 HDMI Splitter with

4Kx2K & EDID Management

Installation Guide

Introduction

The 1x8 HDMI Splitter with 4Kx2K & EDID Management
splits one HDMI signal to eight HDMI displays at up to
4Kx2K resolution.

Key Features and Benefits

• Broadcast HDMI video/audio signals from one
HDMI source to eight displays without losing
quality

• Supports HDMI Deep Color & 3D

• Supports 1080p and up to 4Kx2K PC resolution

• Supports Dolby Digital, DTS-HD and Dolby True­HD audio

• Video bandwidth: 340MHz (10.2Gbps)

• Embedded default EDID and EDID learning ability

Package Contents

• 1x8 HDMI Splitter with 4Kx2K & EDID Management

• Power adapter (Output: 5V/4A)

• Power cord

• Mounting screws (2)

• Installation guide

04-0947A

1

Layout

DC 5V

MODE

F/W
HDMI
OUT 1

HDMI
OUT 2-4

Figure 1: Rear Panel

• HDMI IN: Connects to your HDMI source device by

using an HDMI cable (cable not included)

• HDMI OUT 1-8 (left to right): Connects to your

HDMI

IN

HDMI

OUT 5-8

HDMI displays by using HDMI cables (cables not
included)

• F/W: For future firmware update

• MODE: Selects alternate EDID modes and functions.
See Mode Dial in page 3 & 4

• DC 5V: Power adapter jack for the included 5V

power adapter

POWER
LED

SIGNAL

LED

• POWER LED: On when the Splitter is powered on

• SIGNAL LED: On when HDMI source is detected

2

Figure 2: Front Panel

Hardware Installation

1. Power off all devices you plan to connect to the
Splitter.

2. Connect your HDMI source's HDMI output to the
Splitter's HDMI IN using an HDMI cable (HDMI
cable not included).

3. Connect your HDMI displays to the Splitter's HDMI
OUT using HDMI cables (HDMI cables not
included).

4. Connect the included power adapter to the Splitter's
DC 5V power jack and plug it into a reliable power
outlet.

5. Power on all of the connected devices.

6. The Splitter is now ready to use.

NOTE: To achieve 3D and 2Kx4K output, make
sure this standard is supported by your display(s),
and High Speed HDMI cables with Ethernet are
used.

Mode Dial

EDID is used to transmit the make, model and
characteristics of a monitor to the display adapter of the
computer. It is also used by an HDTV to identify it's
maximum resolution to the DVD player, A/V receiver or
video processor. Use a flat head screwdriver to rotate the
Mode Dial to select amongst the options.

3