SIIG 1x2 HDMI Distribution Amplifier with 3D and 4K x 2K Quick Installation Manual

1 x 2 HDMI Distribution
Amplifier with 3D and

4K x 2K
Quick Installation Guide

Introduction

The 1x2 HDMI Distribution Amplifier with 3D and 4K x 2K
provides the most cost effective and advanced HDMI
splitter solution by which high definition video and high
quality audio can be transmitted to 2 different locations
without losing quality.

Features and Benefits

• Broadcasts HDMI signals from one source to two
displays

• Supports HDMI Deep Color & 3D

• Supports video bandwidth up to 340MHz (10.2Gbps)

• Supports 1080p and up to 4Kx2K PC resolution

• Automatic EDID learning

Package Contents

• 1x2 HDMI Distribution Amplifier with 3D and 4K x 2K

• Power adapter (5V) & power cord

• Screw kit

• Quick installation guide

04-0847A

1

Layout

Status
LED

HDMI In

HDMI Out

Figure 1: Rear Panel

RS-232

DIP
Switch

Power
LED

DC In

• Status LED: Indicates the status of the splitter.
Green LED means the transmission signal is detected

• HDMI In: Connect your HDMI source here

• HDMI Out 1 & 2: Connect your HDMI displays here

• RS-232: For firmware update use only

• DIP Switch: Changes between normal work mode
and firmware update mode. Please keep the switch
down at position 1 for normal work mode. See the
instructions on page 5 for firmware update, if needed

• Power LED: Power LED in red light means the
power is on

• DC In: Power jack for 5V/4A DC power adapter

2

Hardware Installation

General instructions for connecting devices are provided
below. Please consult your device's users manual for
more information, if needed.

1. Power off all devices, including monitors.

2. Connect your HDMI source (such as a Blu-ray DVD
player) to the HDMI In.

3. Connect your HDMI display(s) to the HDMI Out(s).
(HDMI 1.4 TV recommended)

4. Plug in 5V 4A DC power supply.

5. Power on all devices.

Notes

1. For transmitting over long distance and high
definition transmission, we suggest an HDMI over
CAT 5/6 extender.

2. When a new display is connected to the splitter, the
splitter will automatically configure the connected
display. Please wait several seconds for the signal
output, this delay is normal.

3