SIIG 04-0414D User Manual

CyberSerial Dual
ExpressCard

Quick Installation Guide

Introducing the CyberSerial ExpressCard

The CyberSerial Dual ExpressCard adds two high-speed
serial ports to an ExpressCard equipped computer.

Features and Benefits

• Compatible with hi-speed modems, monitoring
equipment, serial networking and other serial
devices

• Two DB9 RS232 ports with 16550 UART

• Supports data rate of up to 115 Kbps

• Built-in 16-byte FIFO buffers dramatically increase

data transmit/receive speed, especially under
Windows multitasking environment

System Requirements

• Notebook or desktop computer with an available
ExpressCard slot

• Windows® 2000/XP (32-/64-bit)/Server 2003
(32-/64-bit)/Vista (32-bit)

Package Contents

• CyberSerial Dual ExpressCard

• 2-Port DB9 Fan-out Cable

• Driver CD

• Quick Installation Guide

04-0414D

1

Layout

Fan-out Cable
Connector

Figure 1: CyberSerial Dual ExpressCard

2-Port DB9 Fan-out Cable

ExpressCard
Connector

2S

Figure 2: 2-Port DB9 Fan-out Cable

Note: Connect 2S to the Fan-out Cable
Connector of the CyberSerial Dual ExpressCard.
See Figure 1 above for more information.

2

DB9 Serial Ports

Hardware Installation

General instructions for installing the ExpressCard are
provided below. Since the design of notebook computers

vary, refer to your system’s reference manual for further

information, if needed.

1. Insert the CyberSerial Dual ExpressCard into the

ExpressCard slot of the computer with it's Express
Card Connector facing the slot. Push the card into
the slot gently, yet firmly for a solid connection.

Note: Some ExpressCard slots will click when the
ExpressCard is fully inserted into the slot.

2. Connect 2S of the fan-out cable to the Fan-out Cable

Connector of the CyberSerial Dual ExpressCard. See
Figure 1 and 2 on page 2 for more information.

Note: Make sure that the CyberSerial Dual ExpressCard
does not move from side to side when connecting
the fan-out cable, otherwise, the ExpressCard may
eject from the slot.

3. If your system was powered off when you plugged

in the CyberSerial Dual ExpressCard, turn it on and go
to Driver Installation. Otherwise, go directly to
Driver Installation.

Driver Installation

This section provides information on how to install the
CyberSerial Dual ExpressCard drivers.

Windows 2000

1. At the Found New Hardware Wizard, click Next.

2. Select Search for a suitable driver for my device
(recommended), and click Next.

3