Sigtronics Y-ADP-TI User Manual

Sigtronics Y-ADP-TI Adapter Installation Instructions

Description

Sigtronics Y-ADP-TI adapters are designed to simplify
the process of connecting a Sigtronics intercom system
to a radio.

Installation

1. To select an appropriate mounting location for the
adapter, rst connect it up to the radio.

2. Unplug the hand mic from the radio, you may also
have to unhook the cable strain relief, and plug it into
jack on the Y-ADP-TI adapter module.

3. Plug the cord connector of the Sigtronics Y-ADP-TI
adapter into the hand mic connector on radio.

4. Now you are ready to select a mounting location
for the adapter. Select a spot out of the way so that
the adapter and its cables will not interfere with the
normal operation of the vehicle and secure with the
supplied hardware.

5. Route the cable from the Y-ADP-TI adapter and solder
/ insulate the four wires to the matching wires of the
radio input cable from the intercom or MRIM-2 unit.

6. Hook up the speaker wires (2 violet wires) from the
Sigtronics intercom or MRIM-2 unit to the .25 inch ste­reo plug. Connect one violet wire to the Tip and the
other violet wire to the Barrel. Leave the Ring open.

NOTES: Adjust the Sigtronics intercom or MRIM-2 units
transmit and receive levels per their appropriate instal­lation instructions. Your existing radio hand mic and
speaker will still function as normal.

WARRANTY: One year parts and labor.

Hand Mic

White: PTT Low

White: PTT High
Black: Mic Low

Brown: Mic High

4 ft. radio interface cable.

To UltraSound, EAI or MRIM-2.

(Supplied with the Sigtronics intercom)

Plug your hand mic into

the Y-ADP-TI adapter.

Plug this connector into

your mobile radio.

Y-ADP-TI

Adapter

Specialists in “SOUND” Management

178 East Arrow Highway, San Dimas, CA 91773 ( 909 ) 305-9399

10- 8-200 8 y-adp -ti.p df