Signatrol SPYDAQ-1000-HPR, SPYDAQ-1100-HPR, SPYDAQ-1200-HPR User Manual

Warning: This product contains Lithium Ion Batteries and

appropriate handling procedures should be observed.

1. Introduction

The SPYDAQ-1x00-HPR is a powered RF Signal Repeater. The repeater is used for
extending the range for standard spYdaq Transmitter, especially when objects
that restrict signal are involved.

The SPYDAQ-1x00-HPR is available in 3 model variants:

Model Variants

SPYDAQ-1000-HPR 433MHz Version

SPYDAQ-1100-HPR 868MHz Version

SPYDAQ-1200-HPR 916MHz Version

The repeater contains an RF receiver and RF transmitter. The receiver (like the
standard SPYDAQ Base-Station) employs Antenna Diversity; using 2 antennas’s
to listen for SPYDAQ transmitter messages and locking on to the highest signal
path.

The entire configuration for the repeater is done using simple DIP switches at the
rear of the product. These DIP switches will allow the user to receive and transmit
on any of the 4 available radio channels.

The repeater listens and repeats messages from any spYdaq device on the
selected RF channel. If you wish to ignore certain spYdaq transmitter device
addresses, the user can program the unit (via DIP switches) to ignore that
transmitter. This may be appropriate if one transmitter is very close to the base­station already and it is not necessary for the repeater to duplicate the
transmission.

The repeater contains an internal Lithium-Ion rechargeable battery, this battery
will continue to power the repeater and continue normal operation in the event of
failure of the external power source. The life of the battery is dependant on the
number of transmitters on the system and the transmit power setting. Typically
the battery will provide normal operation of 1~2 days.

Note:
The repeater’s internal Lithium-Ion battery will be disconnected via an internal
jumper link prior to leaving the factory. Before commissioning the repeater the
battery jumper link should be fitted. See section 5 in this manual.

SPYDAQ-1000-HPR

Reference: Provisional

Unit E2, Green Lane Business Park,

Tewkesbury, Gloucestershire, GL20 8SJ

Signatrol.com

Tel: [phone]

Change Note: Provisional Page 1 of 6

2. Product Specifications

Provisional Spec, subject to change.

Power Input

RF Receiver

RF Receiver Channel

RF Transmitter Dependant on variant 433, 868 or 916MHz

RF Transmitter Channel

RF Transmit Power Output

Receive

Ignore

Operating Ambient
Temperature

Internal Battery

(Uses 12V PSU supplied) (1A max)

Dependant on variant 433, 868 or 916MHz

Configured by DIP switch (A,B,C and D)

(independent of Transmitter Channel)

Configured by DIP switch (A,B,C and D)

(independent of Receiver Channel)

4 Levels configured by DIP switch

Will repeat any SPYDAQ transmitter

(ID = 0 to 15) on the selected receive

Repeater can be configured to ignore

Non-Serviceable (Factory Replacement

10 to 28 VDC

channel

SPYDAQ device IDs

-13°C to +32°C

Lithium-Ion 2200mAh

Normal Voltage: 3.7V
Charge Voltage: 4.2V

Only)

SPYDAQ-1000-HPR

Reference: Provisional

Unit E2, Green Lane Business Park,

Tewkesbury, Gloucestershire, GL20 8SJ

Signatrol.com

Tel: [phone]

Change Note: Provisional Page 2 of 6