Sig Marine Solid Fuel Heater Installation And Operating Manual
Sig Marine Products
#407-204 Cayer St. Coquitlam
B.C. Canada V3K 5B1
www.sigmarine.com
info@sigmarine.com
T: 800 659 9768
INSTALLATION AND OPERATING MANUAL
This manual must be read and the requirements carried out
to ensure satisfactory performance.
SIG MARINE RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS
QUALITY INSPECTED BY- Doug & Don DATE- Nov 5/2008
OR DOCUMENTS AT ANY TIME
1
WARNINGS AND DISCLOSURES
DO NOT ATTEMPT TO BURN OIL FUELS OR GAS FUELS IN THIS APPLIANCE
CERTAIN BRANDS OF ENGENEERED FIREWOOD BURN WITH AN ENHANCED
LEVEL OF HEAT. READ THE INSTRUCTIONS CAREFULLY AND REFRAIN FROM
BURNING ANY MANUFACTURED WOOD WITH AN ARTIFICIALLY INCREASED
BTU RATING.
THIS HEATER HAS BEEN DESIGNED TO HEAT A SMALL AREA OR AS AN
ESTHETIC FEATURE FOR YOUR BOAT. USE THIS HEATER RESPONSIBLY. DO NOT
OVERFIL THIS HEATER (pg 4).
WHEN USING ENGENEERED FIREWOOD, MORE FREQUENT CLEANING OF THE
FIREBOX AND THE FLUE MAY BE REQUIRED.
FOLLOW ALL INSTALLATION AND OPERATING PROCEDURES
A PERMANENTLY OPEN FRESH AIR INLET MUST BE INSTALLED TO ALLOW AIR
TO ENTER THE BOAT AND PROVIDE COMBUSTION AIR FOR THE HEATER
WARNING: THIS APPLIANCE AND THE EXHAUST PIPE GETS HOT DURING
OPERATION. CARE SHOULD BE TAKEN TO PREVENT INJURY.
DO NOT OPERATE THIS PRODUCT UNATTENDED
LIGHTING INSTRUCTIONS
1. Open the air damper control located on the front of the ash drawer by sliding the
knob to the right side.
2. Close the sliding panel on the front door by unscrewing the brass thumb screw and
sliding the decorative panel down.
3. Open the heater door and load a fire lighter or starter onto the fire grate. Ignite and
add sufficient solid fuel for the fire to start. It is important not to overfill the
combustion chamber (pg 4).
4. Close the door.
5. Once the fire is established the sliding panel may be opened
6. The air damper control can be adjusted to provide fast or extended burning.
Drawer
Adjustment
Maximum
Steel Liner
1/2” Air Space
Door Panel
Fresh Air Inlet
2
45 Degree Elbows
Sliding
Damper
RECOMMENDED INSTALLATION REQUIREMENTS
SOLID FUEL HEATER
Stainless
Ash
Loading...