SIG HRR103 User guide
GENERAL INFORMATION
numerical order.
Your kit contains the following parts. Please check your kit for any missing or damaged parts before starting construction.
All of the parts on the plan are identified by a number or a letter.
Parts identified by a number are laser cut parts.
Parts identified by a letter are stripwood pieces that you cut and fit on assembly.
The slight discoloration of the edges of the laser cut parts may be removed by lightly sanding them with 400 grit
sandpaper.
The assembly of this model begins by building the fuselage side frames and then parts are added or assembled in
COMPLETE KIT PARTS LIST
1 Plan Sheet #1 1 Plan Sheet #2 1 Decal Sheet
3 Yellow Tissue 1 1/16"x12" Music Wire 1 Tail Wheel Assembly
1 15" Thread 2 1/ 8"x4" Solder 3 3 1/4"x6" Window Material
8 1/16"sq.x18" Balsa Strip 12 3/32"sq.x18" Balsa Strip 2 1/8"sq.x18" Balsa Strip
1 3/16"x1 3/4" Dowel 1 Instruction Manual 1 9" Plastic Propeller
1 Propeller Shaft 2 Brass Thrust Washers 1 Plastic Propeller Bearing
2 1/4"x1/2" Black Rubber Tube 2 1/16"x1/16" Plastic Tube 1 6" Copper Wire
1 3/16"x60" Rubber Strip 15 Laser Cut Sheets
Tools and Building Supplies
You will need the following items to assemble this model. You must read and follow all of the manufactures
instructions provided with these items!
-Glue CA, White Glue, Sigment or Ambroid all work well.
-Cutting Tools A single edge razor blade can be used for all of the cutting.
-Clear Dope, Thinner & paint brush -200, 320 and 400 sandpaper
-Straight Pins -Wax Paper
-Needle nose pliers -Crayon or Candle
-1/4" Drill Bit -Building Board
.
sandpaper.
The first thing that you need to do is to identify and mark the part numbers on the laser cut parts using the drawings on the
following pages as a guide.
It is possible that several of the laser cut parts may not be completely cut through. If this is the case you can free the part from
the sheet quickly using an X-acto knife.
NOTE: The slight discoloration on the edges of the laser cut parts may be removed by lightly sanding the edges with 400 grit
.
Loading...