Sierra Wireless Q2438F-M User Manual

Regulatory Information

FCC Regulatory Information

The Federal Communication Commission Radio
Frequency Interference Statement includes the following
paragraph:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy. If not installed
and used in accordance with the instructions, it may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by
tuning the equipment off and on, the user is encouraged
to try and correct the interference by one or more of the
following measures:

-Reorient or relocate the receiving antenna.

-Increase the distance between the equipment and the
receiver.

-Connect the equipment to outlet on a circuit different
from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician
for help.

P/N 7010-0752

1

Safety Warnings

Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.

Federal Communication Commission
Declaration of Conformity (DoC) Statement

Model No: GRS -1

Trade Name Topcon
Responsible Party

Topcon Positioning

Systems, Inc.

7400 National Drive,

Address

Livermore, CA 94551

Telephone No [phone]

Industry Canada (IC) Regulatory Information

This device complies with RSS 210 of Industry Canada.
Operation is subject to the following two conditions:

(1) This device may not cause interference, and
(2) This device must accept any interference, including
interference that may cause undesired operation of this
device.

L ‘ utilization de ce dispositif est autorisée seulement aux
conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’ utilisateur du dispositif doit étre prêt à accepter tout
brouillage radioélectrique reçu, même si ce brouillage est

GRS Operator’s Manual

2

General Warnings

susceptible de compromettre le fomctionnement du
dispositif.

FCC/IC RF Radiation Exposure Statement

For Bluetooth and 802.11b/g

To comply with FCC/IC RF exposure compliance
requirements, this device must not be co-located or
operating in conjunction with any other antenna or
transmitter.

For mobile operation,
To comply with FCC/IC RF exposure compliance
requirements, a separation distance of at least 20cm
must be maintained between the antenna of this device
and all persons. This device must not be co-located or
operating in conjunction with any other antenna or
transmitter.

The installer of this device must ensure that the antenna
is located or pointed such that it does not emit RF field in
excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s
website at www.hc-sc.gc.ca/rpb

In case that the option
CDMA/PCS Module (FCC ID:O9EQ2438F-M /Dosen’t
support AMP)is installed

To comply with FCC/IC RF exposure compliance
requirements, this device has been demonstrated
co-location compliance requirement with
CDMA/PCS Module FCC ID:O9EQ2438F-M, which is an
option for GRS. This device must not be co-located in
conjunction with any other antenna or transmitter.

.

P/N 7010-0752

3