Sierra Designs Flash 2 User Manual
FLASH 2 & 3
(STANDARD MODELS)
PITCHING INSTRUCTIONS
Congratulations on the purchase of you new Sierra Designs Tent! In order to familiarize yourself with
your new tent, we recommend you “test pitch” it before embarking on your wilderness adventure.
PACKAGE INCLUDES: Tent body with attached Rain Fly, 4 Poles, Guy Cords, Stakes, Pole/Stake Bag and Tent Stuff Sack.
STEP 1: Find an even piece of ground; be sure the
area is clear of debris. Layout your tent as shown.
Stake the 4 corners. (circled)
STEP 3: Insert pole tips of green hoop pole in
grommet at corner of tent. Push pole into sleeve
attaching opposite pole tip to grommet on other side.
Note: there will be alot of tension.
STEP 2: Assemble
poles. Insert the long
green poles into the
sleeves that run
parallel to the doors.
STEP 4: Insert one end of the silver pole into ball cap connector
located on the awning of the tent. Then insert the other side
erecting the hoops.
Corner Grommet
STEP 5: Attach all clips to the silver pole and install the short green
ridge pole ON TOP of the silver pole using the ball cap connectors.
Ball Cap Connector
Ball Cap Connector
Ultralight Clips
STEP 6: Pull the corners of the attached fly over the green
sleeve and clip to corner buckles. Adjust webbing tension.
Stake out gear closets and your tent is pitched.
Corner Buckle
STEP 7: To stow the gear closets, unclip the corner buckles,
roll the fly and clip the center push button.
Center Push Button
FLASH 2 & 3
(STANDARD MODELS)
USING YOUR TENT
TWO PITCH CONFIGURATION:
The Flash features an
integrated rain y that can
quickly and easily be deployed
in two versatile con gurations.
GUYING OUT YOUR TENT: Your tent includes guy out loops,
guylines, and stakes. It is good practice to always guy out your
tent, but is absolutely necessary when it’s windy.
FULL RAIN PROTECTION NIGHT VIEWING
Guy out your Flash tent where shown below
to prevent pole rotation/breakage during
high winds.
Tie the end of the guy line to the
re ective guy out loop on your tent.
Use the black LINE-LOK® to adjust
the length of the guy line.
Stake out the end of the guy line loop
into the ground.
Loading...