Siemens 599 Series, 599-10077 Installation Instructions Manual

Installation Instructions

599 Series Powermite and Zone Valve

1 - Weather shield side, male (bottom)

1 - Weather shield side, female (top)

4 - UV resistant cable ties

CAUTION:

Equipment damage, or loss

specified.

CAUTION:

Actuator Weather Shield

Product Description

The 599 Series Powermite and Zone Valve Actuator
weather shield provides additional protection against
the elements for actuators in outdoor installations.
The cover is easy to install, with all necessary
hardware included in the assembly kit.

NOTES:

• This unit is approved for outdoor installation
only when a weatherproof conduit connec tor
is used.

• The weather shield provides NEMA 3R
protection against rain, sleet and damage
from external ice formation when installed in
the orientation shown in Figure 3.

Contents

Document No. 129-431

October 5, 2009

Installation

1. Punch a hole through weather shield at the
preferred conduit location.

2. Install male side (bottom) of weather shield over
valve. See Figure 1.

Figure 1.

Product Number

599-10077

Caution Notation

of data may occur if you do
not follow procedures as

Required Tool

Conduit knockout punch

Expected Installation Time

15 minutes

Item Number 129-431, Rev. 010

Page 1 of 2

3. Install actuator on to valve. See Figure 1.

NOTE: See Figure 3 for mounting restrictions.

4. Connect conduit to weather shield using a

weatherproof conduit connection.

5. Wire actuator according to installation

instructions.

6. Place female side (top) of weather shield over

bottom of installed weather shield (male side).

7. Align holes in the weather shield side flanges and

secure with four cable ties. See Figure 2.

Figure 2. Installed Weather Shield.

Over-tightening cable ties can damage
the assembly.

The installation is now complete.

Document Number 129-431

Siemens Indus try, Inc.

+ 1 847-215-1000

Installation Instructions
October 5, 2009

Mounting

The actuator and Weather Shield must be mounted
vertically to ensure NEMA 3R rating.

Figure 3. Acceptable Mounting Position.

Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models
as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.
©2009 Siemens Industry, Inc.

Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089

Your feedback is important to us. If you have
comments about this document, please send them
to [e-mail]

Document No. 129-396

Printed in the USA

Page 2 of 2