Sichuan AI Link Technology WFR710RTG1 User Manual

WF-R710-RTG1
IEEE 802.11b/g/n 1T1R UART SoC Module
Features
Reserving System
Chip Solution
RTL8710B
I/O Interface & Size
Standard two UART/GPIO I/O Interface Support RF Testing and OTP/Flash Programming
17.7mm x30.0mm x2.9mm
Model Overview
Model
Interface
RF Standard
Data rate
Freqency
I/O
Voltage
Input
WF-R710-RTG1
UART
IEEE 802.11b/g/n
150 Mbps
2.4G
GPIO
3.3V
1. Introduction
WF-R710-RTG1
IEEE 802.11 b/g/n 1T1R UART SoC Module
Sichuan AI-Link Technology Co.,Ltd. page 2 of 9
WF-R710-RTG1 SoC module designed base on RTL8710BN chip solution, The SOC module is a highly intelligent platform for the Internet of Everything that contains a low-power Wi-Fi connectivity solution on one package. It includes a number of TCP/IP based connectivity protocols along with SSL, enabling a low-cost, low-complexity system to obtain full-featured internet connectivity and reliable information exchange.
Realtek RTL8710BN is a highly integrated single-chip low power 802.11n Wireless LAN (WLAN) network controller. It combines an ARM-CM4F MCU, WLAN MAC, a 1T1R capable WLAN baseband, and RF in a single chip. It also provides a bunch of configurable GPIOs which are configured as digital peripherals fordifferent applications and control usage.
RTL8710BN integrates internal memories for complete WIFI protocol functions. The embedded memory configuration also provides simple application developments.
1.1 RF module Overview
The general HW architecture for the module is shown in Figure-1, The WF-R710-RTG1 module is a aloned chipset solution, system-on-chip-module, 1x1 802.11 b/g/n device optimized for low-power embedded applications with single-stream capability for both transmit and receive. It has an integrated network processor with a large set of TCP/IP with IPv4/IPv6 based services.
Figure 1 WF-R710-RTG1 Block Diagram
1.2. RF Specification Reference
WF-R710-RTG1
IEEE 802.11 b/g/n 1T1R UART SoC Module
Sichuan AI-Link Technology Co.,Ltd. page 3 of 9
SoC RF specification refer to below list.
Main Chipset
RTL8710BN-A0
SoC RF standard
IEEE 802.11 b/g/n
Operating Frequency
2.412~2.462 GHz
UART Interface
For testing and OTP programming (Calibration data)
Antenna Design Options
PCB printed
RF Modulation
WIFI: 11b: DBPSK, DQPSK and CCK and DSSS
11a/g: BPSK, QPSK, 16QAM, 64QAM and OFDM 11n: BPSK, QPSK, 16QAM, 64QAM and OFDM
Data rates
11b: 1, 2, 5.5 and 11Mbps 11a/g: 6, 9, 12, 18, 24, 36, 48 and 54 Mbps 11n: 6.5, 13, 19.5, 26, 39, 52, 58.5, 65up to 150 Mbps
Operation Voltage
3.3V +/-10% input
1.3. System Functions
SoC S/W & system general specification refer to below list:
Main Chipset
RTL8710BN
WLAN PHY Features
1T1R
Connective
WIFI Direct support
Package
QFN32 (5x5mm)
Bandwidth
20MHz and 40MHz bandwidth transmission
HW acceleration
WPA,WPA2, WPS2.0
Form factor
Maximum 9 GPIO pins
PCB Stack
2-layers design (1+/-0.15mm)
Module Dimension
Typical17.7mm x30.0mm x2.9mm
Operation Temperature
-20to +85
Storage Temperature
-40to +125
2. Mechanical Specification
Loading...
+ 6 hidden pages