SHYH FONG WM110 00 00 A User Manual

Instruction For WM110

General Setting:

 Press power button for 2 seconds to switch on/off.
 Press power button of Transmitter 2 times to switch on/off Silent Mode.
 Press transmitter up/down button to adjust volume on receiver.
 Press receiver up/down button to adjust channels.
 Press both up & down buttons of receiver at the same time for 2 seconds to

unlock button lock on receiver.

Display:

 Sign “A” means a microphone is connected.
 Sing “B” means two microphone are connected.

Transmitter(Black):

 “- -“ means waiting for connection.
 “UX” means maximum volume. Transmitter control volume from U1-UX.
 “00-19” means channel & “ AU” means auto connection.
 System will shut down automatically if not in connection for over 100

seconds.

 System will shut down automatically if there is no input for over 20

minutes.

Receiver(Blue):

 “00-19” means channel & “ AU” means auto connection.
 Up & Down button will be locked automatically when not in use for over 5

seconds.

 System will shut down automatically if not in connection for over 20

minutes.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate r ad io f r equenc y ener gy and, if not install ed a nd us ed in acc o r danc e with
the instructions, m a y cause harm ful inter ferenc e to rad io comm unic ations. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does

Instruction For WM110

cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the us er is encouraged to tr y to correct the interfer ence by one or
more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

 Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: An y changes or m odifications not expre ssly approve d by the part y responsib le
for compliance could void the user's authority to operate this equipment.

This device com plies with Part 1 5 of the FC C Rules. Operation is subjec t to the f ollowing t wo
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

This device and its ante nna(s) must not be co-located or oper ating in conjunction with any
other antenna or transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF
exposure compliance.